configure to run a xipImage
Hello!
I would like to run a xipImage. I'm sure I have to tell u-boot that this is the case, but how? For the moment I have an xipImage that prints "Magic Bad Number" when I try to start it.
Greetings
---
Joakim Nordell
Quoted 3 lines · In message <[email protected]> you wrote:
I would like to run a xipImage. I'm sure I have to tell u-boot that this is the case, but how? For the moment I have an xipImage that prints "Magic Bad Number" when I try to start it.
This is on PowerPC, I assume?
An XIP image has the following properties: it is not compressed (IH_COMP_NONE), and load address is the current start address in memory (ntohl(hdr->ih_load) == addr); see "common/cmd_bootm.c" lines 320ff.
Best regards,
Wolfgang Denk
Signature · 5 lines
DENX Software Engineering GmbH, HRB 165235 Munich, CEO: Wolfgang Denk
Office: Kirchenstr. 5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
You Don't Have To Be 'Damned' To Work Here, But It Helps!!!
- Terry Pratchett, _Eric_