Skip to contentSkip to conversation

128MB lost... where ?

DISCUSSION Giuliano Pochini 4 participants 5 messages Feb 21, 2001

lore
Share & tools
lore
#0 lore raw

Perhaps this is a faq...
I have a dual-800 (mb asus, no AGP) with 1GB ram, but according to /proc/meminfo tells I only have 900000KB. I tried "mem=1024" boot parameter without success. How can I get my 128MB back ?

Bye.

    Giuliano Pochini ->)|(<- Shiny Corporation {AS6665} ->)|(<-
#1 lore raw
Quoted 7 lines · Giuliano Pochini

Perhaps this is a faq...
I have a dual-800 (mb asus, no AGP) with 1GB ram, but according to /proc/meminfo tells I only have 900000KB. I tried "mem=1024" boot parameter without success. How can I get my 128MB back ?

when you compile your 2.4.x kernel make sure you set the "4G of RAM" option, i.e. CONFIG_HIGHMEM4G. If you chose "up to 1G" then it means "up to 986M" (or something like that) -- the number in Help is just rounded up to confuse the dummy user :)

Regards,
Tigran

#2 lore raw
Quoted 10 lines · Tigran Aivazian
Quoted 7 lines · Giuliano Pochini

Perhaps this is a faq...
I have a dual-800 (mb asus, no AGP) with 1GB ram, but according to /proc/meminfo tells I only have 900000KB. I tried "mem=1024" boot parameter without success. How can I get my 128MB back ?

Quoted 3 lines

when you compile your 2.4.x kernel make sure you set the "4G of RAM" option, i.e. CONFIG_HIGHMEM4G. If you chose "up to 1G" then it means "up to 986M" (or something like that) -- the number in Help is just rounded up

     ~~~

not 986M but (unsigned long)(-PAGE_OFFSET-VMALLOC_RESERVE)>>20 MB which is around 876M or so.

Regards,
Tigran

#3 lore raw
In reply to Giuliano Pochini
Quoted 6 lines · On 21-Feb-2001 Giuliano Pochini wrote:

Perhaps this is a faq...
I have a dual-800 (mb asus, no AGP) with 1GB ram, but according to /proc/meminfo tells I only have 900000KB. I tried "mem=1024" boot parameter without success. How can I get my 128MB back ?

Check Your BIOS setting coz some motherboards reserves main memory fog AGP.

- Davide

#4 lore raw
In reply to Giuliano Pochini
Quoted 11 lines · Giuliano Pochini

Perhaps this is a faq...
I have a dual-800 (mb asus, no AGP) with 1GB ram, but according to /proc/meminfo tells I only have 900000KB. I tried "mem=1024" boot parameter without success. How can I get my 128MB back ?

Bye.

    Giuliano Pochini ->)|(<- Shiny Corporation {AS6665} ->)|(<-

You can't. You have to enable HIGHMEM4G in make config, then rebuild the entire kernel. This doesn't work well with 2.4.1 because many modules will have unresolved symbols. Maybe this has been fixed in a later kernel.

Cheers,
Dick Johnson

Penguin : Linux version 2.4.1 on an i686 machine (799.53 BogoMips).

"Memory is like gasoline. You use it up when you are running. Of course you get it all back when you reboot..."; Actual explanation obtained from the Micro$oft help desk.