usb: pci-quirks: disable D3cold on xhci suspend for s2idle on AMD Renoir
Subsystems (3)
A message that is not in the archive (sent off-list or not yet received): [email protected]
PATCH v2 1/1 usb: pci-quirks: disable D3cold on xhci suspend for s2idle on AMD Renoir
From: Mario Limonciello <[email protected]>
The XHCI controller is required to enter D3hot rather than D3cold for AMD s2idle on this hardware generation.
Otherwise, the 'Controller Not Ready' (CNR) bit is not being cleared by host in resume and eventually this results in xhci resume failures during the s2idle wakeup.
--- drivers/usb/host/xhci-pci.c | 7 ++++++- drivers/usb/host/xhci.h | 1 + 2 files changed, 7 insertions(+), 1 deletion(-)
drivers/usb/host/xhci-pci.c +6 -1
@@ -59,6 +59,7 @@#define PCI_DEVICE_ID_INTEL_MAPLE_RIDGE_XHCI 0x1138#define PCI_DEVICE_ID_INTEL_ALDER_LAKE_XHCI 0x461e +#define PCI_DEVICE_ID_AMD_RENOIR_XHCI 0x1639#define PCI_DEVICE_ID_AMD_PROMONTORYA_4 0x43b9#define PCI_DEVICE_ID_AMD_PROMONTORYA_3 0x43ba#define PCI_DEVICE_ID_AMD_PROMONTORYA_2 0x43bb
@@ -182,6 +183,10 @@ static void xhci_pci_quirks(struct device *dev, struct xhci_hcd *xhci) (pdev->device == PCI_DEVICE_ID_AMD_PROMONTORYA_1))) xhci->quirks |= XHCI_U2_DISABLE_WAKE; +if (pdev->vendor ==PCI_VENDOR_ID_AMD && + pdev->device ==PCI_DEVICE_ID_AMD_RENOIR_XHCI ) + xhci->quirks |=XHCI_BROKEN_D3COLD ; +if (pdev->vendor ==PCI_VENDOR_ID_INTEL ) { xhci->quirks |=XHCI_LPM_SUPPORT ; xhci->quirks |=XHCI_INTEL_HOST ;
@@ -548,7 +553,7 @@ static int xhci_pci_suspend(struct usb_hcd *hcd, bool do_wakeup)* Systems with the TI redriver that loses port status change events * need to have the registers polled during D3, so avoid D3cold. */ -if (xhci->quirks &XHCI_COMP_MODE_QUIRK ) +if (xhci->quirks & (XHCI_COMP_MODE_QUIRK |XHCI_BROKEN_D3COLD ))pci_d3cold_disable (pdev);if (xhci->quirks &XHCI_PME_STUCK_QUIRK )
drivers/usb/host/xhci.h +1 -0
@@ -1884,6 +1884,7 @@ struct xhci_hcd {#define XHCI_DISABLE_SPARSE BIT_ULL(38)#define XHCI_SG_TRB_CACHE_SIZE_QUIRK BIT_ULL(39)#define XHCI_NO_SOFT_RETRY BIT_ULL(40) +#define XHCI_BROKEN_D3COLD BIT_ULL(41)unsigned int num_active_eps;unsigned int limit_active_eps;
Signature · 1 line
2.25.1
Greg Kroah-Hartman
maintainerQuoted 19 lines · Werner Sembach
From: Mario Limonciello <[email protected]>
The XHCI controller is required to enter D3hot rather than D3cold for AMD s2idle on this hardware generation.
Otherwise, the 'Controller Not Ready' (CNR) bit is not being cleared by host in resume and eventually this results in xhci resume failures during the s2idle wakeup.
Suggested-by Prike Liang <[email protected]>Signed-off-by Mario Limonciello <[email protected]>Cc stable <[email protected]> # 5.11+Signed-off-by Greg Kroah-Hartman <[email protected]>(cherry picked from commit d1658268e43980c071dbffc3d894f6f6c4b6732a)Signed-off-by Werner Sembach <[email protected]>
Quoted 5 lines
--- drivers/usb/host/xhci-pci.c | 7 ++++++- drivers/usb/host/xhci.h | 1 + 2 files changed, 7 insertions(+), 1 deletion(-)
Any reason you resent us a patch that is already in a stable release?
And why not just use the stable kernel trees as-is? Why attempt to cherry-pick random portions of them?
thanks,
greg k-h
Am 16.07.21 um 14:50 schrieb Greg Kroah-Hartman:
Quoted 25 lines · Werner Sembach
Quoted 19 lines
From: Mario Limonciello <[email protected]>
The XHCI controller is required to enter D3hot rather than D3cold for AMD s2idle on this hardware generation.
Otherwise, the 'Controller Not Ready' (CNR) bit is not being cleared by host in resume and eventually this results in xhci resume failures during the s2idle wakeup.
Suggested-by Prike Liang <[email protected]>Signed-off-by Mario Limonciello <[email protected]>Cc stable <[email protected]> # 5.11+Signed-off-by Greg Kroah-Hartman <[email protected]>(cherry picked from commit d1658268e43980c071dbffc3d894f6f6c4b6732a)Signed-off-by Werner Sembach <[email protected]>Quoted 5 lines
--- drivers/usb/host/xhci-pci.c | 7 ++++++- drivers/usb/host/xhci.h | 1 + 2 files changed, 7 insertions(+), 1 deletion(-)
Quoted 8 lines
Any reason you resent us a patch that is already in a stable release?
And why not just use the stable kernel trees as-is? Why attempt to cherry-pick random portions of them?
thanks,
greg k-h
I didn't add the mailing list as recipent for my last replies so here again:
I only checked the Ubuntu 5.11 tree where the patch is actually missing.
The 5.8 kernel has other issues because of outdated amdgpu, that's why we never checked the 5.4 kernel.
Testing for 5.4: often hangs on boot before display manager shows up
5.4 + amdgpu-dkms from here: https://www.amd.com/en/support/kb/release-notes/rn-amdgpu-unified-linux-21-20 : Hang on boot issue gone, but does not suspend anymore, and has graphic glitches.
Should I add these findings to the SRU?
Quoted 40 lines · Werner Sembach
Am 16.07.21 um 14:50 schrieb Greg Kroah-Hartman:
Quoted 25 lines · Werner Sembach
Quoted 19 lines
From: Mario Limonciello <[email protected]>
The XHCI controller is required to enter D3hot rather than D3cold for AMD s2idle on this hardware generation.
Otherwise, the 'Controller Not Ready' (CNR) bit is not being cleared by host in resume and eventually this results in xhci resume failures during the s2idle wakeup.
Suggested-by Prike Liang <[email protected]>Signed-off-by Mario Limonciello <[email protected]>Cc stable <[email protected]> # 5.11+Signed-off-by Greg Kroah-Hartman <[email protected]>(cherry picked from commit d1658268e43980c071dbffc3d894f6f6c4b6732a)Signed-off-by Werner Sembach <[email protected]>Quoted 5 lines
--- drivers/usb/host/xhci-pci.c | 7 ++++++- drivers/usb/host/xhci.h | 1 + 2 files changed, 7 insertions(+), 1 deletion(-)Quoted 8 lines
Any reason you resent us a patch that is already in a stable release?
And why not just use the stable kernel trees as-is? Why attempt to cherry-pick random portions of them?
thanks,
greg k-h
I didn't add the mailing list as recipent for my last replies so here again:
I only checked the Ubuntu 5.11 tree where the patch is actually missing.
Quoted 8 lines
The 5.8 kernel has other issues because of outdated amdgpu, that's why we never checked the 5.4 kernel.
Testing for 5.4: often hangs on boot before display manager shows up
5.4 + amdgpu-dkms from here: https://www.amd.com/en/support/kb/release-notes/rn-amdgpu-unified-linux-21-20 : Hang on boot issue gone, but does not suspend anymore, and has graphic glitches.
Should I add these findings to the SRU?
Hi Werner,
This patch is specific to Ubuntu so it should not have been sent to LKML (stable, Greg and others), which you did. I guess that's what Greg meant.
When sending such backports from your tree, be sure to set "suppresscc=all" in your .git/config or use appropriate argument for git send-email.
Best regards,
Krzysztof
Am 16.07.21 um 17:30 schrieb Krzysztof Kozlowski:
Quoted 52 lines · Werner Sembach
Quoted 38 lines
Am 16.07.21 um 14:50 schrieb Greg Kroah-Hartman:
Quoted 25 lines · Werner Sembach
Quoted 19 lines
From: Mario Limonciello <[email protected]>
The XHCI controller is required to enter D3hot rather than D3cold for AMD s2idle on this hardware generation.
Otherwise, the 'Controller Not Ready' (CNR) bit is not being cleared by host in resume and eventually this results in xhci resume failures during the s2idle wakeup.
Suggested-by Prike Liang <[email protected]>Signed-off-by Mario Limonciello <[email protected]>Cc stable <[email protected]> # 5.11+Signed-off-by Greg Kroah-Hartman <[email protected]>(cherry picked from commit d1658268e43980c071dbffc3d894f6f6c4b6732a)Signed-off-by Werner Sembach <[email protected]>Quoted 5 lines
--- drivers/usb/host/xhci-pci.c | 7 ++++++- drivers/usb/host/xhci.h | 1 + 2 files changed, 7 insertions(+), 1 deletion(-)Quoted 8 lines
Any reason you resent us a patch that is already in a stable release?
And why not just use the stable kernel trees as-is? Why attempt to cherry-pick random portions of them?
thanks,
greg k-h
I didn't add the mailing list as recipent for my last replies so here again:
I only checked the Ubuntu 5.11 tree where the patch is actually missing.
Quoted 8 lines
The 5.8 kernel has other issues because of outdated amdgpu, that's why we never checked the 5.4 kernel.
Testing for 5.4: often hangs on boot before display manager shows up
5.4 + amdgpu-dkms from here: https://www.amd.com/en/support/kb/release-notes/rn-amdgpu-unified-linux-21-20 : Hang on boot issue gone, but does not suspend anymore, and has graphic glitches.
Should I add these findings to the SRU?
Hi Werner,
This patch is specific to Ubuntu so it should not have been sent to LKML (stable, Greg and others), which you did. I guess that's what Greg meant.
Quoted 6 lines
When sending such backports from your tree, be sure to set "suppresscc=all" in your .git/config or use appropriate argument for git send-email.
Best regards,
Krzysztof
Hi,
now I see, thanks for spelling it out, I was a little bit slow today. I didn't realize that git send-email added non Ubuntu mailings lists because of the cc in the commit message (besides already should know this because I did it once before by accident).
I'm really really sorry, for all the confusion I caused.
Kind regards
Werner Sembach
Greg Kroah-Hartman
maintainerQuoted 40 lines · Werner Sembach
Am 16.07.21 um 14:50 schrieb Greg Kroah-Hartman:
Quoted 25 lines · Werner Sembach
Quoted 19 lines
From: Mario Limonciello <[email protected]>
The XHCI controller is required to enter D3hot rather than D3cold for AMD s2idle on this hardware generation.
Otherwise, the 'Controller Not Ready' (CNR) bit is not being cleared by host in resume and eventually this results in xhci resume failures during the s2idle wakeup.
Suggested-by Prike Liang <[email protected]>Signed-off-by Mario Limonciello <[email protected]>Cc stable <[email protected]> # 5.11+Signed-off-by Greg Kroah-Hartman <[email protected]>(cherry picked from commit d1658268e43980c071dbffc3d894f6f6c4b6732a)Signed-off-by Werner Sembach <[email protected]>Quoted 5 lines
--- drivers/usb/host/xhci-pci.c | 7 ++++++- drivers/usb/host/xhci.h | 1 + 2 files changed, 7 insertions(+), 1 deletion(-)Quoted 8 lines
Any reason you resent us a patch that is already in a stable release?
And why not just use the stable kernel trees as-is? Why attempt to cherry-pick random portions of them?
thanks,
greg k-h
I didn't add the mailing list as recipent for my last replies so here again:
I only checked the Ubuntu 5.11 tree where the patch is actually missing.
Quoted 8 lines
The 5.8 kernel has other issues because of outdated amdgpu, that's why we never checked the 5.4 kernel.
Testing for 5.4: often hangs on boot before display manager shows up
5.4 + amdgpu-dkms from here: https://www.amd.com/en/support/kb/release-notes/rn-amdgpu-unified-linux-21-20 : Hang on boot issue gone, but does not suspend anymore, and has graphic glitches.
Should I add these findings to the SRU?
What does any of this have to do with the [email protected] developers?