Skip to contentSkip to conversation

arm64: dts: meson: sm1: add Ethernet PHY reset line for ODROID-C4/HC4

PATCH Applied Dongjin Kim 3 participants 3 messages Aug 26, 2021 – Sep 13, 2021

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 arm64: dts: meson: sm1: add Ethernet PHY reset line for ODROID-C4/HC4

This patch is to fix an issue that the ethernet link doesn't come up when using ip link set down/up:

   [   11.428114] meson8b-dwmac ff3f0000.ethernet eth0: Link is Down
   [   14.428595] meson8b-dwmac ff3f0000.ethernet eth0: PHY [0.0:00] driver [RTL8211F Gigabit Ethernet] (irq=31)
   [   14.428610] meson8b-dwmac ff3f0000.ethernet: Failed to reset the dma
   [   14.428974] meson8b-dwmac ff3f0000.ethernet eth0: stmmac_hw_setup: DMA engine initialization failed
   [   14.711185] meson8b-dwmac ff3f0000.ethernet eth0: stmmac_open: Hw setup failed

This fix has been referred two commits applied for ODROID-N2 (G12B).

    commit 658e4129bb81 ("arm64: dts: meson: g12b: odroid-n2: add the Ethernet PHY reset line")
    commit 1c7412530d5d0 ("arm64: dts: meson: g12b: odroid-n2: fix PHY deassert timing requirements")
---
 arch/arm64/boot/dts/amlogic/meson-sm1-odroid.dtsi | 4 ++++
 1 file changed, 4 insertions(+)
arch/arm64/boot/dts/amlogic/meson-sm1-odroid.dtsi +4 -0
index d14716b3d0f1..1230beba04aa 100644
@@ -256,6 +256,10 @@ external_phy: ethernet-phy@0 {
 		reg = <0>;
 		max-speed = <1000>;
 
+		reset-assert-us = <10000>;
+		reset-deassert-us = <80000>;
+		reset-gpios = <&gpio GPIOZ_15 (GPIO_ACTIVE_LOW | GPIO_OPEN_DRAIN)>;
+
 		interrupt-parent = <&gpio_intc>;
 		/* MAC_INTR on GPIOZ_14 */
 		interrupts = <26 IRQ_TYPE_LEVEL_LOW>;
Signature · 1 line
2.30.2
reviewer Reviewed-by on v1 1/1
#1 lore raw

Hi,

Thanks for this patch!

my first suggestion is about the patch subject (first line):
arm64: dts: meson-sm1-odroid: add Ethernet PHY reset for ODROID-C4/HC4

This makes it match the pattern of the most recent commits there:
45d736ab17b4 arm64: dts: meson-sm1-odroid: add 5v regulator gpio 7881df513680 arm64: dts: meson-sm1-odroid: set tf_io regulator gpio as open source

Quoted 9 lines · Dongjin Kim

This patch is to fix an issue that the ethernet link doesn't come up when using ip link set down/up:

   [   11.428114] meson8b-dwmac ff3f0000.ethernet eth0: Link is Down
   [   14.428595] meson8b-dwmac ff3f0000.ethernet eth0: PHY [0.0:00] driver [RTL8211F Gigabit Ethernet] (irq=31)
   [   14.428610] meson8b-dwmac ff3f0000.ethernet: Failed to reset the dma
   [   14.428974] meson8b-dwmac ff3f0000.ethernet eth0: stmmac_hw_setup: DMA engine initialization failed
   [   14.711185] meson8b-dwmac ff3f0000.ethernet eth0: stmmac_open: Hw setup failed
Quoted 3 lines

This fix has been referred two commits applied for ODROID-N2 (G12B).

    commit 658e4129bb81 ("arm64: dts: meson: g12b: odroid-n2: add the Ethernet PHY reset line")
    commit 1c7412530d5d0 ("arm64: dts: meson: g12b: odroid-n2: fix PHY deassert timing requirements")

I am not 100% sure but I think you can just add two "Fixes: ..." tags here That way this patch is also backported automatically

Quoted 1 line
#2 lore raw
In reply to Dongjin Kim

Hi,

Quoted 9 lines · Dongjin Kim

This patch is to fix an issue that the ethernet link doesn't come up when using ip link set down/up:

   [   11.428114] meson8b-dwmac ff3f0000.ethernet eth0: Link is Down
   [   14.428595] meson8b-dwmac ff3f0000.ethernet eth0: PHY [0.0:00] driver [RTL8211F Gigabit Ethernet] (irq=31)
   [   14.428610] meson8b-dwmac ff3f0000.ethernet: Failed to reset the dma
   [   14.428974] meson8b-dwmac ff3f0000.ethernet eth0: stmmac_hw_setup: DMA engine initialization failed
   [   14.711185] meson8b-dwmac ff3f0000.ethernet eth0: stmmac_open: Hw setup failed

[...]

Thanks, Applied to https://git.kernel.org/pub/scm/linux/kernel/git/amlogic/linux.git (v5.16/dt64)

[1/1] arm64: dts: meson: sm1: add Ethernet PHY reset line for ODROID-C4/HC4

      https://git.kernel.org/amlogic/c/9d02214f8332d5dbbcce3d6c5c915e54d43a0c46
Signature · 1 line
Neil