counter: 104-quad-8: Remove reference in Kconfig to 25-bit counter value
PATCH 1/1 counter: 104-quad-8: Remove reference in Kconfig to 25-bit counter value
Support for 25-bit counter values was removed in commit 4aa3b75c7460 ("counter: 104-quad-8: Fix race condition between FLAG and CNTR reads"). Adjust the Kconfig description of CONFIG_104_QUAD_8 to remove reference of 25-bit counter values.
Signed-off-by William Breathitt Gray <[email protected]>
--- drivers/counter/Kconfig | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)
drivers/counter/Kconfig +3 -3
@@ -21,9 +21,9 @@ config 104_QUAD_8 encoder counter/interface device family (104-QUAD-8, 104-QUAD-4). A counter's respective error flag may be cleared by performing a write - operation on the respective count value attribute. Although the - 104-QUAD-8 counters have a 25-bit range, only the lower 24 bits may be - set, either directly or via the counter's preset attribute. + operation on the respective count value attribute. The 104-QUAD-8 + counters may be set either directly or via the counter's preset + attribute. The base port addresses for the devices may be configured via the base array module parameter. The interrupt line numbers for the devices may
base-commit: 09a9639e56c01c7a00d6c0ca63f4c7c41abe075d
Signature · 1 line
2.39.2
Quoted 6 lines · William Breathitt Gray
Support for 25-bit counter values was removed in commit
4aa3b75c7460("counter: 104-quad-8: Fix race condition between FLAG and CNTR reads"). Adjust theKconfigdescription ofCONFIG_104_QUAD_8to remove reference of 25-bit counter values.Signed-off-by William Breathitt Gray <[email protected]>
Applied to counter-next of the Counter tree.
William Breathitt Gray