arm64: dts: mt7986: increase bl2 partition on NAND of Bananapi R3
Subsystems (2)
PATCH 1/1 arm64: dts: mt7986: increase bl2 partition on NAND of Bananapi R3
The bootrom burned into the MT7986 SoC will try multiple locations on the SPI-NAND flash to load bl2 in case the bl2 image located at the the previously attempted offset is corrupt.
Use 0x100000 instead of 0x80000 as partition size for bl2 on SPI-NAND, allowing for up to four redundant copies of bl2 (typically sized a bit less than 0x40000).
--- .../boot/dts/mediatek/mt7986a-bananapi-bpi-r3-nand.dtso | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)
arch/arm64/boot/dts/mediatek/mt7986a-bananapi-bpi-r3-nand.dtso +3 -3
@@ -29,13 +29,13 @@ partitions { partition@0 { label = "bl2"; - reg = <0x0 0x80000>; + reg = <0x0 0x100000>; read-only; }; - partition@80000 { + partition@100000 { label = "reserved"; - reg = <0x80000 0x300000>; + reg = <0x100000 0x280000>; }; partition@380000 {
Signature · 1 line
2.41.0
Quoted 10 lines · Daniel Golle
The bootrom burned into the MT7986 SoC will try multiple locations on the SPI-NAND flash to load bl2 in case the bl2 image located at the the previously attempted offset is corrupt.
Use
0x100000instead of0x80000as partition size for bl2 on SPI-NAND, allowing for up to four redundant copies of bl2 (typically sized a bit less than0x40000).Fixes 8e01fb15b8157 ("arm64: dts: mt7986: add Bananapi R3")Signed-off-by Daniel Golle <[email protected]>
Applied, thanks!
Quoted 25 lines
--- .../boot/dts/mediatek/mt7986a-bananapi-bpi-r3-nand.dtso | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)arch/arm64/boot/dts/mediatek/mt7986a-bananapi-bpi-r3-nand.dtso +3
-3@@ -29,13 +29,13 @@ partitions { partition@0 { label = "bl2"; - reg = <0x0 0x80000>; + reg = <0x0 0x100000>; read-only; }; - partition@80000 { + partition@100000 { label = "reserved"; - reg = <0x80000 0x300000>; + reg = <0x100000 0x280000>; }; partition@380000 {