Functional enhancement of max31827
Dear hwmon community,
I developed the driver for the max31827 temperature sensor, but when doing so I omitted some functionalities of the chip, namely: PEC Error, Fault Queue, Comp/Int, Alarm Polarity, Resolution, Timeout and PEC Enable. I did not implement these, because there are no predefined attributes in the linux kernel which have similar meaning to these funcionalities.
I recently got a request from the client to implement these functionalities. I want to use SENSOR_DEVICE_ATTR to implement these. I did some reading and saw that using debufs is also a possibility.
I would be really greatful, if you could provide me with some advices. Should I proceed with device attributes defined by me? Should I use debufs? Maybe there is another and better way...
Thank you in advance for your response!
Kind regards,
Daniel
Link to driver: https://github.com/torvalds/linux/blob/master/drivers/hwmon/max31827.c
Link to datasheet: https://www.analog.com/media/en/technical-documentation/data-sheets/MAX31827-MAX31829.pdf#page=13&zoom=220,-9,487
Guenter Roeck
maintainerQuoted 9 lines · Daniel Matyas
Dear hwmon community,
I developed the driver for the max31827 temperature sensor, but when doing so I omitted some functionalities of the chip, namely: PEC Error, Fault Queue, Comp/Int, Alarm Polarity, Resolution, Timeout and PEC Enable. I did not implement these, because there are no predefined attributes in the linux kernel which have similar meaning to these funcionalities.
Quoted 8 lines
I recently got a request from the client to implement these functionalities. I want to use
SENSOR_DEVICE_ATTRto implement these. I did some reading and saw that using debufs is also a possibility.I would be really greatful, if you could provide me with some advices. Should I proceed with device attributes defined by me? Should I use debufs? Maybe there is another and better way...
pec related attributes should be attached to the i2c interface. Other drivers already do that; look for pec_{show,store}. The same is true for timeout.
Comp/Int and Alarm polarity are system properties which should be set via devicetree.
For others I am not sure. Fault Queue also smells like a system property since normally one would only modify it if a given system requires it (for example because the sensors are noisy). The same is true for sensor resolution, though that one is closest for considering a sysfs attribute. For most sensors, the resolution is closely related to conversion time and can be handled with that attribute. I think that isn't the case here, and there are numerous chips where the resolution is configurable, so it may make sense to consider a sysfs attribute.
Guenter