MTD Driver problem/question with 384MB MD2202-D384.

I saw a message in the archive from June 2003, but there was no response that I could find.

This is the DiskOnChip I concerned about.

Its the 384MB - The MD2202-D384.
Under Linux with a 2.4.27 patched with MTD kernel

Now I have followed the instructions on building a DOC system from OReilly's Building Embedded Systems book. And its pretty straight forward. Building/patching the kernel (version 2.4.27) with the MTD drivers. However it claims that the MTD drivers don't work with DOCs with firmware version 5.0 or larger. Now I don't know if this is still the case. Now the book advises replacing the firmware with the Version 4.2 firmware. However, this fails on the 384 MB DOC. Now when I compile the kernel and run it, and it doesn't seem to find the DOC.

I have to ask is the MD2202-D384 supported by MTD? Is there a work around to get this DOC to work with MTD. Or am I missing something and this should all be working.

I would like to note, that I actually have tested a MD2202-D32-X (32MB) DOC (w/ version 4.2 firmware), and it seems to work. I haven't extensively tested it, but it is accessible, which is further than I have gotten on the 384MB Version.

Any help that can be provided will be greatly appreciated.

Thank you,
Ed

Which DoC driver are you using ?
drivers/mtd/devices/doc...
or
drivers/mtd/nand/diskonchip.c

The latter is the one we support. Can you try it ?

The DoC firmware version is not really relevant for the first step. The first step is to make sure, that the chip driver itself recognizes the devices correctly. The firmware version is relevant for the (I)NFTL drivers, which can only work when the device can be handled by the low level driver.

tglx