Skip to contentSkip to conversation

2.6.13-rc1-mm1 -- Synaptics touchpad not detected correctly

DISCUSSION Miles Lane 2 participants 2 messages Jul 3, 2005

lore
Share & tools
lore

Miles Lane

author
#0 lore raw

Hello,

Any ideas why my Synaptics touchpad isn't getting recognized as supporting multi-finger tap detection? I haven't seen detection work with earlier kernels, either. However, multifinger taps work under WinXP.

dmesg is reporting:

           Synaptics Touchpad, model: 1, fw: 5.10, id: 0x258eb1, caps:

0xa04713/0x0
input: SynPS/2 Synaptics TouchPad on isa0060/serio1

On the web, I found this reference:
http://www.softwarelibremorelos.gob.mx/pipermail/slm/2005-March/001267.html
Which, for 2.6.10, shows:
Synaptics Touchpad, model: 1
Firmware: 5.10
Sensor: 37
new absolute packet format
Touchpad has extended capability bits
-> multifinger detection
-> palm detection
input: SynPS/2 Synaptics TouchPad on isa0060/serio1

My .config contains:

CONFIG_INPUT_MOUSEDEV=y
CONFIG_INPUT_MOUSEDEV_PSAUX=y
CONFIG_INPUT_MOUSEDEV_SCREEN_X=1280
CONFIG_INPUT_MOUSEDEV_SCREEN_Y=768
# CONFIG_INPUT_JOYDEV is not set
# CONFIG_INPUT_TSDEV is not set
CONFIG_INPUT_EVDEV=y
# CONFIG_INPUT_EVBUG is not set

#
# Input Device Drivers
#
CONFIG_INPUT_KEYBOARD=y
CONFIG_KEYBOARD_ATKBD=y
# CONFIG_KEYBOARD_SUNKBD is not set
# CONFIG_KEYBOARD_LKKBD is not set
# CONFIG_KEYBOARD_XTKBD is not set
# CONFIG_KEYBOARD_NEWTON is not set
CONFIG_INPUT_MOUSE=y
CONFIG_MOUSE_PS2=m

CONFIG_SERIO=y
CONFIG_SERIO_I8042=y
CONFIG_SERIO_SERPORT=m
CONFIG_SERIO_CT82C710=m
CONFIG_SERIO_PCIPS2=m
CONFIG_SERIO_LIBPS2=y

#1 lore raw
Quoted 7 lines · Miles Lane

Hello,

Any ideas why my Synaptics touchpad isn't getting recognized as supporting multi-finger tap detection? I haven't seen detection work with earlier kernels, either. However, multifinger taps work under WinXP.

Quoted 5 lines

dmesg is reporting:

           Synaptics Touchpad, model: 1, fw: 5.10, id: 0x258eb1, caps:

0xa04713/0x0
input: SynPS/2 Synaptics TouchPad on isa0060/serio1

It looks like it is recognized. Bit 1 in the caps word tells if the touchpad supports multi-finger detection. Earlier kernels used to report this in plain text form, but it was considered bloating dmesg unnecessarily, so now you only get the raw capability bits reported.

Anyway, you also need to use the X driver from

        http://web.telia.com/~u89404340/touchpad/index.html

to take advantage of multi-finger taps. The kernel itself doesn't bind any special actions to them.

Signature · 2 lines
Peter Osterlund - [email protected]
http://web.telia.com/~u89404340