arm64: dts: freescale: imx93-var-som: Align dts adding missing components
Hi all,
the current device tree for the i.MX93 VAR-SOM is incomplete. In particular, several peripherals that are present on the hardware are not yet described, such as:
- audio codec
- PMIC
- WiFi + Bluetooth module
My plan is to align the DTS with the actual hardware by adding these missing nodes.
Before preparing the patches, I would like to ask for your advice:
should I send one patch that performs the full DTS alignment (describing the patch as an alignemnt of the dts with the actual hardware), or would you prefer a patch series with one patch per peripheral (e.g. one for codec, one for PMIC, one for WiFi/BT, etc.)?
I will do the same with the other Variscite SOMs and Carrier Boards
Thanks for your guidance.
Best regards,
Stefano
Fabio Estevam
reviewerHi Stefano,
Quoted 5 lines · Stefano Radaelli
Before preparing the patches, I would like to ask for your advice:
should I send one patch that performs the full DTS alignment (describing the patch as an alignemnt of the dts with the actual hardware), or would you prefer a patch series with one patch per peripheral (e.g. one for codec, one for PMIC, one for WiFi/BT, etc.)?
Sending a patch series with one patch per peripheral is preferred.
Hi Fabio,
Quoted 5 lines · Fabio Estevam
Hi Stefano,
On Mon, Sep 22, 2025 at 1:11 PM Stefano Radaelli
<[email protected]> wrote:
Quoted 7 lines
Quoted 5 lines
Before preparing the patches, I would like to ask for your advice:
should I send one patch that performs the full DTS alignment (describing the patch as an alignemnt of the dts with the actual hardware), or would you prefer a patch series with one patch per peripheral (e.g. one for codec, one for PMIC, one for WiFi/BT, etc.)?Sending a patch series with one patch per peripheral is preferred.
Great, thank you so much for the info!
Best Regards,
Stefano