Skip to contentSkip to conversation

lcd

U-Boot Anusha Bhat 3 participants 3 messages Feb 7, 2009

lore
Share & tools
lore
#0 lore raw

Hi,
How to add LCD SUPPORT (CONFIG_LCD) to opma3evm bootcode(u-boot).if i add CONFIG_LCD in the omap3evm.h it gives error.
Because the display variables and funtions are not defined for omap.
I wanted to display a bmp logo on u-boot up

#1 lore raw
Quoted 5 lines · Anusha Bhat

Hi,
How to add LCD SUPPORT (CONFIG_LCD) to opma3evm bootcode(u-boot).if i add CONFIG_LCD in the omap3evm.h it gives error.
Because the display variables and funtions are not defined for omap.
I wanted to display a bmp logo on u-boot up

Why do you cross post to omap-linux?

Anyway, do you talk about splash screen? If yes, do you like to have a look to (hackish, and therefore not in mainline) patch for Beagle?

http://groups.google.com/group/beagleboard/browse_thread/thread/3ad9b803a3418624

Regards

Dirk

#2 lore raw
In reply to Anusha Bhat

Anusha,
Anusha Bhat said the following on 02/06/2009 11:44 PM:

Quoted 5 lines

How to add LCD SUPPORT (CONFIG_LCD) to opma3evm bootcode(u-boot).if i add CONFIG_LCD in the omap3evm.h it gives error.
Because the display variables and funtions are not defined for omap.
I wanted to display a bmp logo on u-boot up

yep, it is probably not supported in omap3 port in latest u-boot at the moment. for OMAP3 DSS configuration code, look at [1] - you need to port this code from the old u-boot to the latest u-boot.
This is a community development, so, we welcome any new features folks can provide..

Regards,
Nishanth Menon
Ref:
[1]
http://beagleboard.googlecode.com/files/u-boot-beagle-rev2-trial2.tar.gz.gz