Skip to contentSkip to conversation

2.4.18 & 2.4.19 IDE chipset clash? Promise PDC20267/SvrWks CSB5

DISCUSSION Jeff Johnson 3 participants 3 messages Sep 4, 2002

lore
Share & tools
lore
#0 lore raw

Greetings,

I am trying to get a kernel running on an Intel SCB2 board. It has
onboard Promise PDC20267 RAID and Serverworks IDE controllers. The problem I am seeing is when Promise support is compiled into the kernel the Serverworks IDE chip will appear but fail to become available. The CDROM drive attached to the Serverworks chip is never visible. If I disable the Promise chip in the board's bios and boot the same kernel the serverworks IDE attaches and the CDROM shows up and can be accessed.

I have tried both 2.4.18 and 2.4.19 source and played with different
config combinations. Nothing I change appears to correct the problem.

I am pretty sure this is something I am doing and not a bug. If someone
would be kind enough to look at the dmesg and /proc/pci excerpts below along with the kernel config options below I would be grateful.

Thank You,

Jeff

dmesg excerpt
-------------
PDC20267: IDE controller on PCI bus 00 dev 10
PDC20267: chipset revision 2
PDC20267: not 100% native mode: will probe irqs later
PDC20267: ROM enabled at 0xfe7e0000
PDC20267: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER Mode.

    ide0: BM-DMA at 0x1440-0x1447, BIOS settings: hda:pio, hdb:pio
    ide1: BM-DMA at 0x1448-0x144f, BIOS settings: hdc:pio, hdd:DMA

SvrWks CSB5: IDE controller on PCI bus 00 dev 79
PCI: Device 00:0f.1 not available because of resource collisions SvrWks CSB5: (ide_setup_pci_device:) Could not enable device.
hda: IC35L040AVVN07-0, ATA DISK drive
ide0 at 0x1400-0x1407,0x140a on irq 19
blk: queue c03ced44, I/O limit 4095Mb (mask 0xffffffff)

pci excerpt
-----------
PCI devices found:
Bus 0, device 2, function 0:

    RAID bus controller: Promise Technology, Inc. 20267 (rev 2).
      IRQ 19.
      Master Capable.  Latency=64.
      I/O at 0x1400 [0x1407].
      I/O at 0x1408 [0x140b].
      I/O at 0x1410 [0x1417].
      I/O at 0x140c [0x140f].
      I/O at 0x1440 [0x147f].
      Non-prefetchable 32 bit memory at 0xfe7a0000 [0xfe7bffff].
  Bus  0, device  15, function  1:
    IDE interface: ServerWorks CSB5 IDE Controller (rev 146).
      Master Capable.  Latency=64.
      I/O at 0x0 [0x7].
      I/O at 0x0 [0x3].
      I/O at 0x0 [0x7].
      I/O at 0x0 [0x3].
      I/O at 0x3a0 [0x3af].
      I/O at 0x410 [0x413].

kernel config
-------------
CONFIG_IDE=y
CONFIG_BLK_DEV_IDE=y
CONFIG_BLK_DEV_IDECD=m
CONFIG_BLK_DEV_IDEDISK=y
CONFIG_BLK_DEV_OFFBOARD=y
CONFIG_BLK_DEV_PDC202XX=y
CONFIG_PDC202XX_FORCE=y
CONFIG_PDC202XX_BURST=y
CONFIG_BLK_DEV_SVWKS=y
# CONFIG_BLK_DEV_OSB4 is not set
CONFIG_BLK_DEV_ATARAID=y
CONFIG_BLK_DEV_ATARAID_PDC=y

#1 lore raw
Quoted 3 lines · Jeff Johnson

SvrWks CSB5: IDE controller on PCI bus 00 dev 79
PCI: Device 00:0f.1 not available because of resource collisions SvrWks CSB5: (ide_setup_pci_device:) Could not enable device.

You need a current -ac tree for this to work. Im working on getting all the bits needed into Marcelo's tree to fix it without feeding him IDE updates

#2 lore raw
In reply to Jeff Johnson
Quoted 9 lines · Jeff Johnson

Greetings,

I am trying to get a kernel running on an Intel SCB2 board. It has
onboard Promise PDC20267 RAID and Serverworks IDE controllers. The problem I am seeing is when Promise support is compiled into the kernel the Serverworks IDE chip will appear but fail to become available. The CDROM drive attached to the Serverworks chip is never visible. If I disable the Promise chip in the board's bios and boot the same kernel the serverworks IDE attaches and the CDROM shows up and can be accessed.

You must force the Promise IDE support. And you should use an -ac kernel because the Promise RAID support there is much better.

Regards
Henning

Signature · 5 lines
Dipl.-Inf. (Univ.) Henning P. Schmiedehausen       -- Geschaeftsfuehrer
INTERMETA - Gesellschaft fuer Mehrwertdienste mbH     [email protected]

Am Schwabachgrund 22  Fon.: 09131 / 50654-0   [email protected]
D-91054 Buckenhof     Fax.: 09131 / 50654-20