x86/kvm: Preserve BSP MSR_KVM_POLL_CONTROL across suspend/resume
Subsystems (2)
Sasha Levin
maintainerPATCH 1/2 x86/kvm: Preserve BSP MSR_KVM_POLL_CONTROL across suspend/resume
From: Wanpeng Li <[email protected]>
[ Upstream commit 0361bdfddca20c8855ea3bdbbbc9c999912b10ff ]
MSR_KVM_POLL_CONTROL is cleared on reset, thus reverting guests to host-side polling after suspend/resume. Non-bootstrap CPUs are restored correctly by the haltpoll driver because they are hot-unplugged during suspend and hot-plugged during resume; however, the BSP is not hotpluggable and remains in host-sde polling mode after the guest resume. The makes the guest pay for the cost of vmexits every time the guest enters idle.
Fix it by recording BSP's haltpoll state and resuming it during guest resume.
Message-Id: <[email protected]>
--- arch/x86/kernel/kvm.c | 13 +++++++++++++ 1 file changed, 13 insertions(+)
arch/x86/kernel/kvm.c +13 -0
@@ -59,6 +59,7 @@ static DEFINE_PER_CPU_DECRYPTED(struct kvm_vcpu_pv_apf_data, apf_reason) __align DEFINE_PER_CPU_DECRYPTED(struct kvm_steal_time, steal_time) __aligned(64) __visible;static int has_steal_clock =0 ; +static int has_guest_poll =0 ;/* * No need for any "IO delay" on KVM */
@@ -584,14 +585,26 @@ static int kvm_cpu_down_prepare(unsigned int cpu)static int kvm_suspend (void ) { +u64 val =0 ; +kvm_guest_cpu_offline (false); +#ifdef CONFIG_ARCH_CPUIDLE_HALTPOLL +if (kvm_para_has_feature (KVM_FEATURE_POLL_CONTROL )) +rdmsrl (MSR_KVM_POLL_CONTROL , val); + has_guest_poll = !(val &1 ); +#endif return 0 ; }static void kvm_resume (void ) {kvm_cpu_online (raw_smp_processor_id ()); + +#ifdef CONFIG_ARCH_CPUIDLE_HALTPOLL +if (kvm_para_has_feature (KVM_FEATURE_POLL_CONTROL ) && has_guest_poll) +wrmsrl (MSR_KVM_POLL_CONTROL ,0 ); +#endif }static struct syscore_ops kvm_syscore_ops = {
Signature · 1 line
2.35.1
Sasha Levin
maintainerPATCH 2/2 KVM: LAPIC: Enable timer posted-interrupt only when mwait/hlt is advertised
From: Wanpeng Li <[email protected]>
[ Upstream commit 1714a4eb6fb0cb79f182873cd011a8ed60ac65e8 ]
As commit 0c5f81dad46 ("KVM: LAPIC: Inject timer interrupt via posted interrupt") mentioned that the host admin should well tune the guest setup, so that vCPUs are placed on isolated pCPUs, and with several pCPUs surplus for *busy* housekeeping. In this setup, it is preferrable to disable mwait/hlt/pause vmexits to keep the vCPUs in non-root mode.
However, if only some guests isolated and others not, they would not have any benefit from posted timer interrupts, and at the same time lose VMX preemption timer fast paths because kvm_can_post_timer_interrupt() returns true and therefore forces kvm_can_use_hv_timer() to false.
By guaranteeing that posted-interrupt timer is only used if MWAIT or HLT are done without vmexit, KVM can make a better choice and use the VMX preemption timer and the corresponding fast paths.
Message-Id: <[email protected]>
--- arch/x86/kvm/lapic.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)
arch/x86/kvm/lapic.c +2 -1
@@ -118,7 +118,8 @@ static inline u32 kvm_x2apic_id(struct kvm_lapic *apic)bool kvm_can_post_timer_interrupt (struct kvm_vcpu *vcpu) { -return pi_inject_timer &&kvm_vcpu_apicv_active (vcpu); +return pi_inject_timer &&kvm_vcpu_apicv_active (vcpu) && + (kvm_mwait_in_guest (vcpu->kvm) ||kvm_hlt_in_guest (vcpu->kvm)); }EXPORT_SYMBOL_GPL (kvm_can_post_timer_interrupt);
Signature · 1 line
2.35.1
Re: [PATCH MANUALSEL 5.4 2/2] KVM: LAPIC: Enable timer posted-interrupt only when mwait/hlt is advertised
Quoted 36 lines · Sasha Levin
From: Wanpeng Li <[email protected]>
[ Upstream commit
1714a4eb6fb0cb79f182873cd011a8ed60ac65e8]As commit
0c5f81dad46("KVM: LAPIC: Inject timer interrupt via posted interrupt") mentioned that the host admin should well tune the guest setup, so that vCPUs are placed on isolated pCPUs, and with several pCPUs surplus for *busy* housekeeping. In this setup, it is preferrable to disable mwait/hlt/pause vmexits to keep the vCPUs in non-root mode.However, if only some guests isolated and others not, they would not have any benefit from posted timer interrupts, and at the same time lose VMX preemption timer fast paths because
kvm_can_post_timer_interrupt()returns true and therefore forceskvm_can_use_hv_timer()to false.By guaranteeing that posted-interrupt timer is only used if MWAIT or HLT are done without vmexit, KVM can make a better choice and use the VMX preemption timer and the corresponding fast paths.
Reported-by Aili Yao <[email protected]>Reviewed-by Sean Christopherson <[email protected]>Cc Aili Yao <[email protected]>Cc Sean Christopherson <[email protected]>Signed-off-by Wanpeng Li <[email protected]>Message-Id: <[email protected]>
Signed-off-by Paolo Bonzini <[email protected]>Signed-off-by Sasha Levin <[email protected]>--- arch/x86/kvm/lapic.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)arch/x86/kvm/lapic.c +0
-0
arch/x86/kvm/lapic.c static inline u32 kvm_x2apic_id(struct kvm_lapic *apic) · line 125
Quoted 9 lines
arch/x86/kvm/lapic.c +2
-1@@ -118,7 +118,8 @@ static inline u32 kvm_x2apic_id(struct kvm_lapic *apic)bool kvm_can_post_timer_interrupt (struct kvm_vcpu *vcpu) { -return pi_inject_timer &&kvm_vcpu_apicv_active (vcpu); +return pi_inject_timer &&kvm_vcpu_apicv_active (vcpu) && + (kvm_mwait_in_guest (vcpu->kvm) ||kvm_hlt_in_guest (vcpu->kvm)); }EXPORT_SYMBOL_GPL (kvm_can_post_timer_interrupt);
Quoted 53 lines · Sasha Levin
From: Wanpeng Li <[email protected]>
[ Upstream commit
0361bdfddca20c8855ea3bdbbbc9c999912b10ff]
MSR_KVM_POLL_CONTROLis cleared on reset, thus reverting guests to host-side polling after suspend/resume. Non-bootstrap CPUs are restored correctly by the haltpoll driver because they are hot-unplugged during suspend and hot-plugged during resume; however, the BSP is not hotpluggable and remains in host-sde polling mode after the guest resume. The makes the guest pay for the cost of vmexits every time the guest enters idle.Fix it by recording BSP's haltpoll state and resuming it during guest resume.
Cc Marcelo Tosatti <[email protected]>Signed-off-by Wanpeng Li <[email protected]>Message-Id: <[email protected]>
Signed-off-by Paolo Bonzini <[email protected]>Signed-off-by Sasha Levin <[email protected]>--- arch/x86/kernel/kvm.c | 13 +++++++++++++ 1 file changed, 13 insertions(+)arch/x86/kernel/kvm.c +8
-0@@ -59,6 +59,7 @@ static DEFINE_PER_CPU_DECRYPTED(struct kvm_vcpu_pv_apf_data, apf_reason) __align DEFINE_PER_CPU_DECRYPTED(struct kvm_steal_time, steal_time) __aligned(64) __visible;static int has_steal_clock =0 ; +static int has_guest_poll =0 ;/* * No need for any "IO delay" on KVM */ @@ -584,14 +585,26 @@ static int kvm_cpu_down_prepare(unsigned int cpu)static int kvm_suspend (void ) { +u64 val =0 ; +kvm_guest_cpu_offline (false); +#ifdef CONFIG_ARCH_CPUIDLE_HALTPOLL +if (kvm_para_has_feature (KVM_FEATURE_POLL_CONTROL )) +rdmsrl (MSR_KVM_POLL_CONTROL , val); + has_guest_poll = !(val &1 ); +#endif return 0 ; }static void kvm_resume (void )
arch/x86/kernel/kvm.c static int kvm_cpu_down_prepare(unsigned int cpu) · line 610
Quoted 10 lines
arch/x86/kernel/kvm.c +5
-0{kvm_cpu_online (raw_smp_processor_id ()); + +#ifdef CONFIG_ARCH_CPUIDLE_HALTPOLL +if (kvm_para_has_feature (KVM_FEATURE_POLL_CONTROL ) && has_guest_poll) +wrmsrl (MSR_KVM_POLL_CONTROL ,0 ); +#endif }static struct syscore_ops kvm_syscore_ops = {