Skip to contentSkip to conversation

RAID1 removal

DISCUSSION Norman Zhang 1 participant 3 messages Jun 20, 2003 – Jun 23, 2003 MD RAID

lore
Share & tools
lore
#0 lore raw

Hi,

I tried to remove a hot-swap RAID1 SCSI disk from the chassis. So I issued the following command

Quoted 2 lines

raidsetfaulty /dev/md4 /dev/sdd6
raidhotremove /dev/md4 /dev/sdd6

But got the following message,

/dev/md4: cannot hot-remove disk: disk is not in array!

So I presume the disk is offline or something, and issued the following command

echo "scsi remove-single-device 1 0 3 0" > /proc/scsi/scsi

When I checked the newly created /proc/scsi/scsi, the device is still listed in the file. I checked /proc/mdstat and saw the following

md4: active raid1 scsi/host1/bus0/target2/lun0/part6[0]

     521984 blocks [2/1][U_]

How do I remove the device, so I can add a new device to reconstruct the array again? Please give me a few pointers?

Regards,
Norman

#1 lore raw
Quoted 3 lines · [email protected] wrote:

You just need change the disk now and use the 'hotadd' tool to insert the new one into the raid. I think could be great update the file /etc/raidtab too.

So I don't need to remove drive from /proc/scsi/scsi?

Quoted 3 lines

About you are looking in /proc/mdstat ... you see only a disk on a 2 disk raid. Where is the second one? out ... u got that using the setfaulty...

The faulty disk is still in the chassis. I pull the disk out by accident and stuck it back in afterwards 8( But I did set raidsetfaulty after that as described below.

Regards,
Norman

Quoted 24 lines
Quoted 24 lines

I tried to remove a hot-swap RAID1 SCSI disk from the chassis. So I issued the following command

Quoted 2 lines

raidsetfaulty /dev/md4 /dev/sdd6
raidhotremove /dev/md4 /dev/sdd6

But got the following message,

/dev/md4: cannot hot-remove disk: disk is not in array!

So I presume the disk is offline or something, and issued the following command

echo "scsi remove-single-device 1 0 3 0" > /proc/scsi/scsi

When I checked the newly created /proc/scsi/scsi, the device is still listed in the file. I checked /proc/mdstat and saw the following

md4: active raid1 scsi/host1/bus0/target2/lun0/part6[0]

     521984 blocks [2/1][U_]

How do I remove the device, so I can add a new device to reconstruct the array again? Please give me a few pointers?

#2 lore raw
Quoted 8 lines

system_lists wrote:

Well, u have got that disk out of the Raid so its not in use.

So you must (I THINK BUT I HAVENT DONE ANYTIME ... when I have needed to upgrade a Raid I have always programed a shutdown in the server):

Quoted 6 lines

1- remove the drive
2- remove the drive from the proc (from the kernel) 3- add a new drive
4- add a new drive in proc (in the kernel) 5- do some checks ...
6- add the drive into the Raid with 'raidhotadd'

Thanks. I just did a raidhotadd the drives are now back in sync. I see the drive is in the array again.

Regards,
Norman