Skip to contentSkip to conversation

New: Intel AC9260 wifi does not get DHCP IP - SuSE 15 kernel 4.12.14-25.16-default

Bug 201383 [email protected] 1 participant 3 messages Oct 11, 2018 – Oct 12, 2018

lore
Share & tools
lore
#0 lore raw

https://bugzilla.kernel.org/show_bug.cgi?id=201383

            Bug ID: 201383
           Summary: Intel AC9260 wifi does not get DHCP IP - SuSE 15
                    kernel 4.12.14-25.16-default
           Product: Backports project
           Version: unspecified
    Kernel Version: 4.12.14-25.16-default
          Hardware: Intel
                OS: Linux
              Tree: Mainline
            Status: NEW
          Severity: high
          Priority: P1
         Component: Backports
          Assignee: [email protected]
          Reporter: [email protected]
        Regression: No

4.12.14-25.16-default #1 SMP Thu Aug 23 10:02:38 UTC 2018 (a5893c4) x86_64 x86_64 x86_64 GNU/Linux

Followed the below steps to configure, however not receiving IPv4 IP address from the router. Please suggest.

Steps:
=====
• Installed iw and wpa_supplicant packages.
• Verified the presence of the card
sles15sp0:linux_test>dmesg | grep 9260

[   74.125592] iwlwifi 0000:06:00.0: Detected Intel(R) Dual Band Wireless AC

9260, REV=0x324
• Verified SLES image rev
sles15sp0:linux_test>uname -a
Linux sles15sp0 4.12.14-25.16-default #1 SMP Thu Aug 23 10:02:38 UTC 2018 (a5893c4) x86_64 x86_64 x86_64 GNU/Linux
You have new mail in /var/mail/root
sles15sp0:linux_test>
• Looked for the wireless interface in the system and brought it up
sles15sp0:linux_test>iw dev
phy#0

        Interface wlan0
                ifindex 6
                wdev 0x1
                addr 94:b8:6d:87:4b:1e
                type managed

You have new mail in /var/mail/root
sles15sp0:linux_test>ip link show wlan0
6: wlan0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN mode DEFAULT group default qlen 1000

    link/ether 94:b8:6d:87:4b:1e brd ff:ff:ff:ff:ff:ff

sles15sp0:linux_test>ip link set wlan0 up

sles15sp0:linux_test>ip link show wlan0

6: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN mode DEFAULT group default qlen 1000

    link/ether 94:b8:6d:87:4b:1e brd ff:ff:ff:ff:ff:ff

sles15sp0:linux_test>iw wlan0 link
Not connected.

• Scanned for available wifi access points and verified that security
type = PSK
sles15sp0:linux_test>iw wlan0 scan | fgrep -i ssid

        SSID: NETGEAR48-5G-2
        SSID: NETGEAR48
        SSID: Verizon-MiFi5510L-EFC7
        SSID: NETGEAR48-5G-1

sles15sp0:linux_test>iw wlan0 scan | fgrep -i Authentication
* Authentication suites: PSK
* Authentication suites: PSK
* Authentication suites: PSK
* Authentication suites: PSK

• Created a WPA configuration file

sles15sp0:linux_test>wpa_passphrase NETGEAR48 smoothgiant416 > wpa.conf sles15sp0:linux_test>cat wpa.conf

network={
        ssid="NETGEAR48"
        #psk="smoothgiant416"
        psk=61d3dc46d102862ce4077862bc2f04d060b4b882deff43bbe4b10d8a4a041138
}

• Looked up the drivers present in the system and ran wpa_supplicant
sles15sp0:linux_test>lsmod | grep -e Used -e iwl

Module                  Size  Used by
iwlmvm                425984  0
mac80211              888832  1 iwlmvm
iwlwifi               258048  1 iwlmvm
cfg80211              696320  3 iwlmvm,iwlwifi,mac80211

You have new mail in /var/mail/root

sles15sp0:linux_test>wpa_supplicant -B -Dcfg80211 -iwlan0 -c ./wpa.conf Successfully initialized wpa_supplicant
wlan0: Unsupported driver 'cfg80211'

sles15sp0:linux_test>wpa_supplicant -B -Dwext -iwlan0 -c /tmp/wpa.conf Successfully initialized wpa_supplicant

• Checking if the association between Wifi AP ( our lab router ) and
wlan0 (wifi interface) is in place.

sles15sp0:linux_test>iw dev wlan0 link
Connected to cc:40:d0:83:49:c1 (on wlan0)
SSID: NETGEAR48
freq: 2412
RX: 2927 bytes (49 packets)
TX: 1941 bytes (20 packets)
signal: -62 dBm
tx bitrate: 14.4 MBit/s MCS 8 short GI

bss flags: CTS-protection short-preamble short-slot-time
dtim period: 2
beacon int: 200
You have new mail in /var/mail/root

sles15sp0:linux_test>iw dev wlan0 info
Interface wlan0

        ifindex 6
        wdev 0x1
        addr 94:b8:6d:87:4b:1e
        ssid NETGEAR48
        type managed
        wiphy 0
        channel 1 (2412 MHz), width: 20 MHz, center1: 2412 MHz

sles15sp0:linux_test>

• Try to obtain a DHCP IP from router.
• This is where the problem lies, even if we are associated with the
access point we are not getting an IP(IPV4) back from router sles15sp0:linux_test>dhclient wlan0
You have new mail in /var/mail/root

sles15sp0:linux_test>ip addr show wlan0
6: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000

    link/ether 94:b8:6d:87:4b:1e brd ff:ff:ff:ff:ff:ff
    inet6 fe80::96b8:6dff:fe87:4b1e/64 scope link
       valid_lft forever preferred_lft forever

sles15sp0:linux_test>

Signature · 3 lines
You are receiving this mail because:
You are the assignee for the bug.--
To unsubscribe from this list: send the line "unsubscribe backports" in
#1 lore raw

[Bug 201383] Intel AC9260 wifi does not get DHCP IP - SuSE 15 kernel 4.12.14-25.16-default

https://bugzilla.kernel.org/show_bug.cgi?id=201383

Ashutosh ([email protected]) changed:

What |Removed |Added
----------------------------------------------------------------------------

          Component|Backports                   |Wireless
            Version|unspecified                 |2.5
            Product|Backports project           |Networking
Signature · 3 lines
You are receiving this mail because:
You are the assignee for the bug.--
To unsubscribe from this list: send the line "unsubscribe backports" in
#2 lore raw

[Bug 201383] Intel AC9260 wifi does not get DHCP IP - SuSE 15 kernel 4.12.14-25.16-default

In reply to [email protected]

https://bugzilla.kernel.org/show_bug.cgi?id=201383

Emmanuel Grumbach ([email protected]) changed:

What |Removed |Added
----------------------------------------------------------------------------

          Component|Wireless                    |network-wireless
           Assignee|[email protected]   |[email protected]
            Product|Networking                  |Drivers
Signature · 3 lines
You are receiving this mail because:
You are the assignee for the bug.--
To unsubscribe from this list: send the line "unsubscribe backports" in