New: Linux Kernel will shows "Got wrong page" in kernel log when Linux kernel tries to send SCSI ModeSense command with Page code 0x08 (Caching Mode Page)

https://bugzilla.kernel.org/show_bug.cgi?id=63141

            Bug ID: 63141
           Summary: Linux Kernel will shows "Got wrong page" in kernel log
                    when Linux kernel tries to send SCSI ModeSense command
                    with Page code 0x08 (Caching Mode Page)
           Product: IO/Storage
           Version: 2.5
    Kernel Version: 3.6.11
          Hardware: All
                OS: Linux
              Tree: Mainline
            Status: NEW
          Severity: low
          Priority: P1
         Component: SCSI
          Assignee: [email protected]
          Reporter: [email protected]
        Regression: No

Created attachment 111291
--> https://bugzilla.kernel.org/attachment.cgi?id=111291&action=edit
SourceCodeComparsionBetween2.6.xAnd3.9.1

Reporter: Leo Chen (Li-Chung Chen)
Report Date: 10/16/13

Issue Descrition: In Linux kernel 3.6.11, sd.c file, host calls sd_read_cache_type() function to read physical disk or volume cache type. This function works properly on most physical disks but will fail to read the cache type on LSI raid volume. The error message in Linux Kernel is "Got wrong page".

However, the Linux kernel works properly in kernel 2.6.x.

Suggestion: If we restore below codes from 2.6.x to 3.6.11 in sd.c,sd_read_cache_type()function, then the kernel won't report "got wrong page" in the log.

/* Take headers and block descriptors into account */ len += data.header_length + data.block_descriptor_length;

I also referenced the SPC-4(SCSI Primary Commands - 4) specification from T10 to check if it's LSI firmware problem to response the wrong parameter length to the host. According to the description in SPC below, it looks like LSI logical volume doesn't voilate the specification to response the MODE DATA LENGTH value to host.

[SPC-4 Description about the Mode Parameter]
When using the MODE SENSE command, the MODE DATA LENGTH field indicates the length in bytes of the following
data that is available to be transferred. The mode data length does not include the number of bytes in the MODE
DATA LENGTH field.
[SPC-4 Description about the Mode Parameter]

Therefore, I'd like to suggest the Linux Kernel to add the code above to make the kernel handle the cache reading properly.

You are receiving this mail because:
You are the assignee for the bug.