Skip to contentSkip to conversation

Kernel 2.6.3 i810fb Grub Boot Loader

DISCUSSION Patrick Beard 1 participant 2 messages Mar 18, 2004 – Mar 19, 2004

lore
Share & tools
lore
#0 lore raw

Hi,
Not sure if this is a i810fb issue or not (appologies if its not)

I've been using the i810fb in kernel 2.6.x with no problems on Debian sarge.
Below is the append line I used in Lilo; video=i810fb:vram:2,xres:1024,yres:768,bpp:16,hsync1:30,hsync2:55,vsync1 :50,vsync2:85,accel,mtrr
(note: The hsync and vsync are not the actual values. I'm not at my system and can't remember what they are.)

Last night I switched from using lilo to grub. everything went ok. I added the above to my grub config and rebooted. The console is fine except for one thing. I get what appears to be a block cursor in the middle of the screen. When I log in, the cursor stays in the middle of the screen until I hit enter, it then jumps to the bottom left. From then on it sort of follows what I type but not quite, it remains somewhat out of sync with where the cursor should actually be. I tried using 'hwcur' on the above but this didn't do anything.

I'm using the same parameters that I used with lilo, yet I never had this issue.

Apart from switching back to lilo, is there anything I can try to resolve this?

TIA

Paddy

#1 lore raw

"Patrick Beard" <[email protected]> wrote in message news:[email protected]...

Quoted 7 lines

Hi,
Not sure if this is a i810fb issue or not (appologies if its not)

I've been using the i810fb in kernel 2.6.x with no problems on Debian sarge.
Below is the append line I used in Lilo;

video=i810fb:vram:2,xres:1024,yres:768,bpp:16,hsync1:30,hsync2:55,vsync1

Quoted 1 line

:50,vsync2:85,accel,mtrr

HI again,
Removing the accel option has resolved this. Not sure why I never saw this problem with lilo.
--
Paddy