One interface forwarding (wireless ad-hoc
Hi,
I'm wondering if there's any simple solution. This problem looks very simple, so maybe there's a simple solution that I'm missing, but I couldn't do it yet.
I'm configuring an wireless ad-hoc network with three laptops;
A ---- B ---- C
where A and C can only talk to B, and B can talk to both A and C. A and C cannot talk to each other. I'd like to configure B so that A can talk to C via B (and vice versa). The addresses are,
A: 192.168.0.1
B: 192.168.0.2
C: 192.168.0.3
Since this is an wireless ad-hoc network, every machine has only one (wireless) interface, so B should receive a packet through its interface eth0 and forward it through eth0 again. Currently, A, B, and C only have the same basic routing table;
Kernel IP routing table
Destination Gateway Genmask Flags Metric
Ref Use Iface
192.168.0.0 * 255.255.255.0 U 0
0 0 eth0
169.254.0.0 * 255.255.0.0 U 0
0 0 eth0
127.0.0.0 * 255.0.0.0 U 0
0 0 lo
B cannot forward packets with this routing table. Is there any solution?
Thanks,
Steve
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Re: [LARTC] One interface forwarding (wireless ad-hoc mode)?
Hi!
Quoted 6 lines · Steven Y. Ko
Hi,
I'm wondering if there's any simple solution. This problem looks very simple, so maybe there's a simple solution that I'm missing, but I couldn't do it yet.
Quoted 8 lines
I'm configuring an wireless ad-hoc network with three laptops;
A ---- B ---- C
B cannot forward packets with this routing table. Is there any solution?
Maybe:
# ip forward is a must for a gateway echo "1" > /proc/sys/net/ipv4/ip_forward
Signature · 5 lines
Udv, Nandor _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Re: [LARTC] One interface forwarding (wireless
In reply to Steven Y. KoQuoted 3 lines
Maybe:
# ip forward is a must for a gateway echo "1" > /proc/sys/net/ipv4/ip_forward
I'm sorry that I forgot mentioning that I turned it on. Also there's no firewall, either. Thank you so much for your answer, though. I'm still figuring out how to do it.
- Steve
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Re: [LARTC] One interface forwarding (wireless ad-hoc mode)?
In reply to Steven Y. KoHi!
Quoted 8 lines · Steven Y. Ko
Quoted 3 lines
Maybe:
# ip forward is a must for a gateway echo "1" > /proc/sys/net/ipv4/ip_forwardI'm sorry that I forgot mentioning that I turned it on. Also there's no firewall, either. Thank you so much for your answer, though. I'm still figuring out how to do it.
It should work.
If i were you, i would play with tcpdump a little bit, to narrow where the problem is.
Signature · 5 lines
Udv, Nandor _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/