Skip to contentSkip to conversation

How to add a new ram region ?

DISCUSSION Franck 2 participants 3 messages Sep 23, 2005 – Sep 26, 2005

lore
Share & tools
lore

Franck

author
#0 lore raw

Hi,

I'm working on port of linux 2.6.13. The target is a custom board based on a MIPS cpu. There are several RAMs on this board whose address are not contiguous and don't start to 0 . I currently succeed to make linux detect one of these RAM (the biggest one) but I'd like to make linux able to use the others...I'd like to use the other in a particular way: I would like to be able to allocate memory only on a single RAM when needed in kernel space, and in userspace I would be able to export a RAM disk that uses memory on a single RAM.

Could someone tell me how to do that or give me some pointers ?

Thanks
--
Franck

#1 lore raw
Quoted 11 lines · On Fri, 23 Sep 2005 09:49:43 +0200 Franck wrote:

Hi,

I'm working on port of linux 2.6.13. The target is a custom board based on a MIPS cpu. There are several RAMs on this board whose address are not contiguous and don't start to 0 . I currently succeed to make linux detect one of these RAM (the biggest one) but I'd like to make linux able to use the others...I'd like to use the other in a particular way: I would like to be able to allocate memory only on a single RAM when needed in kernel space, and in userspace I would be able to export a RAM disk that uses memory on a single RAM.

Quoted 1 line

Could someone tell me how to do that or give me some pointers ?

You can try the "memmap=" kernel boot options, although I don't know if or how well they apply to MIPS. Some of them apparently do apply, according to Documentation/kernel-parameters.txt .

---
~Randy
You can't do anything without having to do something else first. -- Belefant's Law

author
#2 lore raw

Hi Randy,

2005/9/24, Randy.Dunlap <[email protected]>:

Quoted 13 lines · On Fri, 23 Sep 2005 09:49:43 +0200 Franck wrote:
Quoted 12 lines

Hi,

I'm working on port of linux 2.6.13. The target is a custom board based on a MIPS cpu. There are several RAMs on this board whose address are not contiguous and don't start to 0 . I currently succeed to make linux detect one of these RAM (the biggest one) but I'd like to make linux able to use the others...I'd like to use the other in a particular way: I would like to be able to allocate memory only on a single RAM when needed in kernel space, and in userspace I would be able to export a RAM disk that uses memory on a single RAM.

Quoted 6 lines
Quoted 1 line

Could someone tell me how to do that or give me some pointers ?

You can try the "memmap=" kernel boot options, although I don't know if or how well they apply to MIPS. Some of them apparently do apply, according to Documentation/kernel-parameters.txt .

I looked at this kernel boot option and it seems that every given RAM regions cannot be used separetly: once they're registered, I can't allocate a page for a given region. Is that correct ?

Thanks
--
Franck