Fix some typos in doc and man pages
Subsystems (2)
cover Fix some typos in doc and man pages
As per description, this series contains some typo fixes on doc and man pages.
- patch 1/3 fixes a typo in a devlink example
- patch 2/3 fixes typos on some man pages
- patch 3/3 fixes a typo in the tc actions doc
Andrea Claudi (3):
man: devlink-region: fix typo in example
man: fix some typos
doc: fix 'infact' --> 'in fact' typo
doc/actions/actions-general | 2 +- man/man8/dcb-app.8 | 2 +- man/man8/dcb-dcbx.8 | 2 +- man/man8/devlink-dev.8 | 2 +- man/man8/devlink-region.8 | 2 +- 5 files changed, 5 insertions(+), 5 deletions(-)
Signature · 1 line
2.35.3
PATCH RESEND 1/3 man: devlink-region: fix typo in example
devlink-region does not accept the legth param, but the length one.
Fixes 8b4fbf0bed8e ("devlink: Add support for devlink-region access")
Signed-off-by Andrea Claudi <[email protected]>
--- man/man8/devlink-region.8 | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
man/man8/devlink-region.8 +1 -1
@@ -116,7 +116,7 @@ devlink region dump pci/0000:00:05.0/cr-space snapshot 1 Dump the snapshot taken from cr-space address region with ID 1 .RE .PP -devlink region read pci/0000:00:05.0/cr-space snapshot 1 address 0x10 legth 16 +devlink region read pci/0000:00:05.0/cr-space snapshot 1 address 0x10 length 16 .RS 4 Read from address 0x10, 16 Bytes of snapshot ID 1 taken from cr-space address region .RE
Signature · 1 line
2.35.3
PATCH RESEND 2/3 man: fix some typos
In reply to Andrea ClaudiIn dcb-app man page, 'direcly' should be 'directly' In dcb-dcbx man page, 'respecively' should be 'respectively' In devlink-dev man page, 'unspecificed' should be 'unspecified'
Signed-off-by Andrea Claudi <[email protected]>
--- man/man8/dcb-app.8 | 2 +- man/man8/dcb-dcbx.8 | 2 +- man/man8/devlink-dev.8 | 2 +- 3 files changed, 3 insertions(+), 3 deletions(-)
man/man8/dcb-app.8 +1 -1
@@ -170,7 +170,7 @@ priorities that should be assigned to matching traffic. \fIDSCP-MAP\fR uses the array parameter syntax, see .BR dcb (8) for details. Keys are DSCP points, values are priorities assigned to -traffic with matching DSCP. DSCP points can be written either direcly as +traffic with matching DSCP. DSCP points can be written either directly as numeric values, or using symbolic names specified in .B /etc/iproute2/rt_dsfield (however note that that file specifies full 8-bit dsfield values, whereas
man/man8/dcb-dcbx.8 +1 -1
@@ -67,7 +67,7 @@ allows setting both and lets the driver handle it as appropriate. .B cee .TQ .B ieee -The device supports CEE (Converged Enhanced Ethernet) and, respecively, IEEE +The device supports CEE (Converged Enhanced Ethernet) and, respectively, IEEE version of the DCB specification. Typically only one of these will be set, but .B dcb dcbx does not mandate this.
man/man8/devlink-dev.8 +1 -1
@@ -199,7 +199,7 @@ pending this action will reload current firmware image. .B limit no_reset - Specifies limitation on reload action. -If this argument is omitted limit is unspecificed and the reload action is not +If this argument is omitted limit is unspecified and the reload action is not limited. In such case driver implementation may include reset or downtime as needed to perform the actions.
Signature · 1 line
2.35.3
PATCH RESEND 3/3 doc: fix 'infact' --> 'in fact' typo
In reply to Andrea ClaudiSigned-off-by Andrea Claudi <[email protected]>
--- doc/actions/actions-general | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
doc/actions/actions-general +1 -1
@@ -72,7 +72,7 @@ action police mtu 4000 rate 1500kbit burst 90k 2)In order to take advantage of some of the targets written by the iptables people, a classifier can have a packet being massaged by an iptable target. I have only tested with mangler targets up to now. -(infact anything that is not in the mangling table is disabled right now) +(in fact anything that is not in the mangling table is disabled right now) In terms of hooks: *ingress is mapped to pre-routing hook
Signature · 1 line
2.35.3