"Problem with Montavista tool chain to compile uboot for MIPS"
Hi All,
I am working on mips4k based board and using montavista/MIPS tool chain to compile uboot for this board.
When i compile uboot using montavista i am getting binary but when i try to run this on the board, it is not getting executed.
But the same i did with MIPS tool chain and it is working fine.
To know what is happening between two different binaries, i just opened the uboot binary(generated with montavista) in hex editor and saw some extra bytes are inserted in the middle of the binary file( at several locations).
Most of the extra bytes are 0x00's.
This i compared with working file and came to know these diffs.
Is it some thing to do with alignment issue?
Please through some light on this.
Any help will be highly appreciated.
Regards,
Nagi
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20060831/d347cf3f/attachment.htm
Quoted 3 lines · In message <[email protected]> you…
I am working on mips4k based board and using montavista/MIPS tool chain to compile uboot for this board.
...
Quoted 2 lines
When i compile uboot using montavista i am getting binary but when i try to run this on the board, it is not getting executed.
You should contact MontaVista technical support about this. You payed for their software, so use their support, too.
Best regards,
Wolfgang Denk
Signature · 5 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
A man either lives life as it happens to him, meets it head-on and
licks it, or he turns his back on it and starts to wither away.
-- Dr. Boyce, "The Menagerie" ("The Cage"), stardate unknown