Skip to contentSkip to conversation

setting gpio on MX1

DISCUSSION Mildred Frisco 1 participant 1 message Dec 23, 2004

lore
Share & tools
lore
#0 lore raw

Hi,

I am using an MX1-based board and would like to use one of its GPIO pins for interrupt. I tried to initlialize it in arch/arm/mach-xxx/arch.c by the __fixup function. Here's the part of the code I added ...

#include <asm/arch/mx1board-gpio.h>

/* Configure interrupt setting, for bitnum of port configured as input.
* */
void mx1board_init_gpio(void)

{
	int i,j;
	i=mx1_register_gpio(PORT_B,17,INPUT);
	j=mx1_gpio_config_intr(PORT_B,17,POSITIVE_LEVEL);
}  

void mx1board_init_devices(void)

{
	mx1board_init_gpio();
}

static void __init
mx1skx4043_fixup(struct machine_desc *desc, struct param_struct *unused,
char **cmdline, struct meminfo *mi)

{
	mx1board_init_devices();
}

MACHINE_START....

-------

I've generated a kernel image but it only goes until "Uncompressing linux..." The kernel booted successfully when this part is not included yet.

Or maybe I am initializing the gpio in the wrong place or I forgot to call an some function. Is the kernel console already enabled by this time so I can see the kernel messages?

Thanks in advance,
Mildred