Yuan EC372S no frontend
Hello,
I have some problems with a Yuan EC372S card. I am using the latest (rev 7499:1abbd650fe07) v4l-dvb from mercurial head.
The card is correctly detected and the firmware loaded but no frontend is attached to it.
I'm running kernel 2.6.22-14-generic on an Ubuntu Gutsy.
I have attached the relevant output of dmesg and lsusb -v and of course I'll be glad to give more informations if needed.
Regards,
Julien
Bus 006 Device 004: ID 1164:1edc YUAN High-Tech Development Co., Ltd Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 2.00
bDeviceClass 0 (Defined at Interface level) bDeviceSubClass 0 bDeviceProtocol 0 bMaxPacketSize0 64 idVendor 0x1164 YUAN High-Tech Development Co., Ltd idProduct 0x1edc bcdDevice 1.00 iManufacturer 1 YUANRD iProduct 2 STK7700D iSerial 3 0000000001 bNumConfigurations 1
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 46
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 0
bmAttributes 0xa0
(Bus Powered)
Remote Wakeup
MaxPower 500mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 4
bInterfaceClass 255 Vendor Specific Class
bInterfaceSubClass 0
bInterfaceProtocol 0
iInterface 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x01 EP 1 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 1
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x81 EP 1 IN
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 1
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x82 EP 2 IN
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 1
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x83 EP 3 IN
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 1
Device Qualifier (for other device speed):
bLength 10
bDescriptorType 6
bcdUSB 2.00
bDeviceClass 0 (Defined at Interface level) bDeviceSubClass 0 bDeviceProtocol 0
bMaxPacketSize0 64
bNumConfigurations 1
Device Status: 0x0000
(Bus Powered)
[ 6880.516000] dib0700: loaded with support for 7 different device-types [ 6880.516000] dvb-usb: found a 'Yuan EC372S' in cold state, will try to load a firmware [ 6880.520000] dvb-usb: downloading firmware from file 'dvb-usb-dib0700-1.10.fw' [ 6880.624000] dib0700: firmware started successfully. [ 6881.128000] dvb-usb: found a 'Yuan EC372S' in warm state. [ 6881.128000] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. [ 6881.128000] DVB: registering new adapter (Yuan EC372S) [ 6881.220000] dvb-usb: no frontend was attached by 'Yuan EC372S' [ 6881.220000] dvb-usb: Yuan EC372S successfully initialized and connected. [ 6881.220000] dib0700: ir protocol setup failed [ 6881.220000] usbcore: registered new interface driver dvb_usb_dib0700
_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
Uhm... It's strange that it doesn't attach correcly the frontend... could you send your dib0700_devices.c on v4l-dvb/linux/drivers/media/dvb/dvb-usb/ ? Just to verify that it's correct... Did you rebooted after sudo make install (just to check old drivers are not in memory)?
Albert
2008/4/7 Julien Rebetez <[email protected]>:
Quoted 13 lines
Hello,
I have some problems with a Yuan EC372S card. I am using the latest (rev 7499:1abbd650fe07) v4l-dvb from mercurial head.
The card is correctly detected and the firmware loaded but no frontend is attached to it.
I'm running kernel 2.6.22-14-generic on an Ubuntu Gutsy.
I have attached the relevant output of dmesg and lsusb -v and of course I'll be glad to give more informations if needed.
Quoted 9 lines
Regards,
Julien_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
Quoted 7 lines · Julien Rebetez
Hello,
I have some problems with a Yuan EC372S card. I am using the latest (rev 7499:1abbd650fe07) v4l-dvb from mercurial head.
The card is correctly detected and the firmware loaded but no frontend is attached to it.
I just tested current master and it worked for me. Anyhow, tuning still gives only filter timeouts (as earlier).
Quoted 8 lines
I'm running kernel 2.6.22-14-generic on an Ubuntu Gutsy.
I have attached the relevant output of dmesg and lsusb -v and of course I'll be glad to give more informations if needed.
Regards,
Julien
regards
Antti
Signature · 1 line
http://palosaari.fi/
Apr 8 02:22:12 crope-laptop kernel: [ 910.108121] dib0700: loaded with support for 7 different device-types Apr 8 02:22:12 crope-laptop kernel: [ 910.108154] usbcore: registered new interface driver dvb_usb_dib0700 Apr 8 02:22:20 crope-laptop kernel: [ 914.330737] usb 1-8: new high speed USB device using ehci_hcd and address 23 Apr 8 02:22:20 crope-laptop kernel: [ 914.382207] usb 1-8: configuration #1 chosen from 1 choice Apr 8 02:22:20 crope-laptop kernel: [ 914.387576] FW GET_VERSION length: -32 Apr 8 02:22:20 crope-laptop kernel: [ 914.387581] cold: 1 Apr 8 02:22:20 crope-laptop kernel: [ 914.387583] dvb-usb: found a 'Yuan EC372S' in cold state, will try to load a firmware Apr 8 02:22:20 crope-laptop kernel: [ 914.389666] dvb-usb: downloading firmware from file 'dvb-usb-dib0700-1.10.fw' Apr 8 02:22:21 crope-laptop kernel: [ 914.474369] dib0700: firmware started successfully. Apr 8 02:22:21 crope-laptop kernel: [ 914.759587] dvb-usb: found a 'Yuan EC372S' in warm state. Apr 8 02:22:21 crope-laptop kernel: [ 914.759645] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. Apr 8 02:22:21 crope-laptop kernel: [ 914.759808] DVB: registering new adapter (Yuan EC372S) Apr 8 02:22:21 crope-laptop kernel: [ 914.811947] ep 0 read error (status = -32) Apr 8 02:22:21 crope-laptop kernel: [ 914.811955] I2C read failed on address 40 Apr 8 02:22:21 crope-laptop kernel: [ 914.980331] DVB: registering frontend 0 (DiBcom 7000PC)... Apr 8 02:22:21 crope-laptop kernel: [ 914.984082] MT2266: successfully identified Apr 8 02:22:21 crope-laptop kernel: [ 915.150087] dvb-usb: Yuan EC372S successfully initialized and connected.
_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb