arm64: dts: meson-axg-s400: add support for Power Controller & MIPI-DSI PHY
Subsystems (2)
cover arm64: dts: meson-axg-s400: add support for Power Controller & MIPI-DSI PHY
This adds the Power Controller and MIPI DSI PHY nodes to AXG, since the corresponding driver and dt-bindings had been applied for next release.
Dependencies:
- Patch 1: [1] applied for 5.11 in meson-clk tree & [2] merged for 5.10
- Patch 2: [3] & [4] both applied for 5.11 in phy tree
[1] https://lore.kernel.org/r/[email protected]
[2] https://lore.kernel.org/r/[email protected]
[3] https://lore.kernel.org/r/[email protected]
[4] https://lore.kernel.org/r/[email protected]
Neil Armstrong (2):
arm64: dts: meson-axg: add PWRC node
arm64: dts: meson-axg: add MIPI DSI PHY nodes
arch/arm64/boot/dts/amlogic/meson-axg.dtsi | 61 ++++++++++++++++++++++ 1 file changed, 61 insertions(+)
Signature · 7 lines
2.25.1 _______________________________________________ linux-amlogic mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-amlogic
PATCH 1/2 arm64: dts: meson-axg: add PWRC node
This adds the power controller PWRC node and the corresponding ethernet power domain.
--- arch/arm64/boot/dts/amlogic/meson-axg.dtsi | 42 ++++++++++++++++++++++ 1 file changed, 42 insertions(+)
arch/arm64/boot/dts/amlogic/meson-axg.dtsi +42 -0
@@ -12,6 +12,7 @@ #include <dt-bindings/interrupt-controller/arm-gic.h> #include <dt-bindings/reset/amlogic,meson-axg-audio-arb.h> #include <dt-bindings/reset/amlogic,meson-axg-reset.h> +#include <dt-bindings/power/meson-axg-power.h> / { compatible = "amlogic,meson-axg";
@@ -187,6 +188,7 @@ ethmac: ethernet@ff3f0000 { "timing-adjustment"; rx-fifo-depth = <4096>; tx-fifo-depth = <2048>; + power-domains = <&pwrc PWRC_AXG_ETHERNET_MEM_ID>; status = "disabled"; };
@@ -1117,6 +1119,46 @@ clkc: clock-controller { clocks = <&xtal>; clock-names = "xtal"; }; + + pwrc: power-controller { + compatible = "amlogic,meson-axg-pwrc"; + #power-domain-cells = <1>; + amlogic,ao-sysctrl = <&sysctrl_AO>; + resets = <&reset RESET_VIU>, + <&reset RESET_VENC>, + <&reset RESET_VCBUS>, + <&reset RESET_VENCL>, + <&reset RESET_VID_LOCK>; + reset-names = "viu", "venc", "vcbus", + "vencl", "vid_lock"; + clocks = <&clkc CLKID_VPU>, + <&clkc CLKID_VAPB>; + clock-names = "vpu", "vapb"; + /* + * VPU clocking is provided by two identical clock paths + * VPU_0 and VPU_1 muxed to a single clock by a glitch + * free mux to safely change frequency while running. + * Same for VAPB but with a final gate after the glitch free mux. + */ + assigned-clocks = <&clkc CLKID_VPU_0_SEL>, + <&clkc CLKID_VPU_0>, + <&clkc CLKID_VPU>, /* Glitch free mux */ + <&clkc CLKID_VAPB_0_SEL>, + <&clkc CLKID_VAPB_0>, + <&clkc CLKID_VAPB_SEL>; /* Glitch free mux */ + assigned-clock-parents = <&clkc CLKID_FCLK_DIV4>, + <0>, /* Do Nothing */ + <&clkc CLKID_VPU_0>, + <&clkc CLKID_FCLK_DIV4>, + <0>, /* Do Nothing */ + <&clkc CLKID_VAPB_0>; + assigned-clock-rates = <0>, /* Do Nothing */ + <250000000>, + <0>, /* Do Nothing */ + <0>, /* Do Nothing */ + <250000000>, + <0>; /* Do Nothing */ + }; }; };
Signature · 7 lines
2.25.1 _______________________________________________ linux-amlogic mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-amlogic
Re: [PATCH 1/2] arm64: dts: meson-axg: add PWRC node
Quoted 4 lines · Neil Armstrong
This adds the power controller PWRC node and the corresponding ethernet power domain.
Signed-off-by Neil Armstrong <[email protected]>
PATCH 2/2 arm64: dts: meson-axg: add MIPI DSI PHY nodes
In reply to Neil ArmstrongThis adds the nodes for :
- MIPI DSI+PCIe analog phy
- MIPI D-PHY
--- arch/arm64/boot/dts/amlogic/meson-axg.dtsi | 19 +++++++++++++++++++ 1 file changed, 19 insertions(+)
arch/arm64/boot/dts/amlogic/meson-axg.dtsi +19 -0
@@ -1159,6 +1159,12 @@ pwrc: power-controller { <250000000>, <0>; /* Do Nothing */ }; + + mipi_pcie_analog_dphy: phy { + compatible = "amlogic,axg-mipi-pcie-analog-phy"; + #phy-cells = <0>; + status = "disabled"; + }; }; };
@@ -1171,6 +1177,19 @@ mailbox: mailbox@ff63c404 { #mbox-cells = <1>; }; + mipi_dphy: phy@ff640000 { + compatible = "amlogic,axg-mipi-dphy"; + reg = <0x0 0xff640000 0x0 0x100>; + clocks = <&clkc CLKID_MIPI_DSI_PHY>; + clock-names = "pclk"; + resets = <&reset RESET_MIPI_PHY>; + reset-names = "phy"; + phys = <&mipi_pcie_analog_dphy>; + phy-names = "analog"; + #phy-cells = <0>; + status = "disabled"; + }; + audio: bus@ff642000 { compatible = "simple-bus"; reg = <0x0 0xff642000 0x0 0x2000>;
Signature · 7 lines
2.25.1 _______________________________________________ linux-amlogic mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-amlogic
Kevin Hilman
maintainerQuoted 6 lines · Neil Armstrong
This adds the Power Controller and MIPI DSI PHY nodes to AXG, since the corresponding driver and dt-bindings had been applied for next release.
Dependencies:
- Patch 1: [1] applied for 5.11 in meson-clk tree & [2] merged for 5.10
- Patch 2: [3] & [4] both applied for 5.11 in phy tree
Thanks for describing the dependencies in detail.
Looks like only [1] is needed a build time. Could you give me a immutable tag from the clk tree (or clk-meson) I could use in my dt64 branch to ensure my dt64 branch is buildable.
Thanks,
Kevin
Quoted 5 lines
[1] https://lore.kernel.org/r/[email protected]
[2] https://lore.kernel.org/r/[email protected]
[3] https://lore.kernel.org/r/[email protected]
[4] https://lore.kernel.org/r/[email protected]
Quoted 9 lines
Neil Armstrong (2):
arm64: dts: meson-axg: add PWRC node
arm64: dts: meson-axg: add MIPI DSI PHY nodesarch/arm64/boot/dts/amlogic/meson-axg.dtsi | 61 ++++++++++++++++++++++ 1 file changed, 61 insertions(+)Signature · 1 line
2.25.1
_______________________________________________
linux-amlogic mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-amlogic
Hi,
Quoted 9 lines · Kevin Hilman
Quoted 6 lines · Neil Armstrong
This adds the Power Controller and MIPI DSI PHY nodes to AXG, since the corresponding driver and dt-bindings had been applied for next release.
Dependencies:
- Patch 1: [1] applied for 5.11 in meson-clk tree & [2] merged for 5.10
- Patch 2: [3] & [4] both applied for 5.11 in phy tree
Quoted 5 lines
Thanks for describing the dependencies in detail.
Looks like only [1] is needed a build time. Could you give me a immutable tag from the clk tree (or clk-meson) I could use in my dt64 branch to ensure my dt64 branch is buildable.
Here you go:
The following changes since commit 3650b228f83adda7e5ee532e2b90429c03f7b9ec:
Linux 5.10-rc1 (2020-10-25 15:14:11 -0700)
are available in the Git repository at:
git://github.com/BayLibre/clk-meson.git tags/clk-meson-v5.11-headers-1
for you to fetch changes up to cd3caa573ebd1f32727962cf7dead43f5144d080:
dt-bindings: clk: axg-clkc: add MIPI DSI Host clock binding (2020-11-23 09:06:34 +0100)
----------------------------------------------------------------
Amlogic clock headers updates for v5.11
* Add axg's video clocks
----------------------------------------------------------------
Neil Armstrong (2):
dt-bindings: clk: axg-clkc: add Video Clocks
dt-bindings: clk: axg-clkc: add MIPI DSI Host clock binding
include/dt-bindings/clock/axg-clkc.h | 25 +++++++++++++++++++++++++ 1 file changed, 25 insertions(+)
Thanks,
Neil
Quoted 20 lines
Thanks,
Kevin
Quoted 14 lines
[1] https://lore.kernel.org/r/[email protected]
[2] https://lore.kernel.org/r/[email protected]
[3] https://lore.kernel.org/r/[email protected]
[4] https://lore.kernel.org/r/[email protected]Neil Armstrong (2):
arm64: dts: meson-axg: add PWRC node
arm64: dts: meson-axg: add MIPI DSI PHY nodesarch/arm64/boot/dts/amlogic/meson-axg.dtsi | 61 ++++++++++++++++++++++ 1 file changed, 61 insertions(+)Signature · 1 line
2.25.1
Quoted 8 lines · Neil Armstrong
This adds the Power Controller and MIPI DSI PHY nodes to AXG, since the corresponding driver and dt-bindings had been applied for next release.
Dependencies:
- Patch 1: [1] applied for 5.11 in meson-clk tree & [2] merged for 5.10
- Patch 2: [3] & [4] both applied for 5.11 in phy tree[...]
Applied, thanks!
[1/2] arm64: dts: meson-axg: add PWRC node
commit: 2a51ac31449a19bfb815f21f246134d6518ff781
[2/2] arm64: dts: meson-axg: add MIPI DSI PHY nodes
commit: 413b63ddf2f85e84b0824770cf9f42ea768adcb4Best regards,
Signature · 6 lines
Kevin Hilman <[email protected]> _______________________________________________ linux-amlogic mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-amlogic