Skip to contentSkip to conversation

esp handle "select without attention"

PATCH New Artyom Tarasenko 1 participant 1 message Sep 3, 2009

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 esp handle "select without attention"

Up to now "select without attention" was handled the same way as "select with attention". According to

http://www.ibiblio.org/pub/historic-linux/early-ports/Sparc/NCR/NCR53C9X.txt

select without ATN sends the CDB (Command Descriptor Block) directly, whereas select with ATN sends one message phase byte followed by 6, 10, or 12 command phase bytes.

The attached patch implements the behaviour described above.

---

hw/esp.c +21 -5
index cc97eb4..85deb46 100644
@@ -203,14 +203,14 @@ static uint32_t get_cmd(ESPState *s, uint8_t *buf)
     return dmalen;
 }
 
-static void do_cmd(ESPState *s, uint8_t *buf)
+static void do_busid_cmd(ESPState *s, uint8_t *buf,  uint8_t busid)
 {
     int32_t datalen;
     int lun;
 
-    DPRINTF("do_cmd: busid 0x%x\n", buf[0]);
-    lun = buf[0] & 7;
-    datalen = s->current_dev->send_command(s->current_dev, 0, &buf[1], lun);
+    DPRINTF("do_busid_cmd: busid 0x%x\n", busid);
+    lun = busid & 7;
+    datalen = s->current_dev->send_command(s->current_dev, 0, buf, lun);
     s->ti_size = datalen;
     if (datalen != 0) {
         s->rregs[ESP_RSTAT] = STAT_TC;
@@ -229,6 +229,12 @@ static void do_cmd(ESPState *s, uint8_t *buf)
     esp_raise_irq(s);
 }
 
+static void do_cmd(ESPState *s, uint8_t *buf)
+{
+    uint8_t busid = buf[0];
+    do_busid_cmd(s, &buf[1], busid);
+}
+
 static void handle_satn(ESPState *s)
 {
     uint8_t buf[32];
@@ -239,6 +245,16 @@ static void handle_satn(ESPState *s)
         do_cmd(s, buf);
 }
 
+static void handle_s_without_atn (ESPState *s)
+{
+    uint8_t buf[32];
+    int len;
+
+    len = get_cmd(s, buf);
+    if (len)
+        do_busid_cmd(s, buf, 0);
+}
+
 static void handle_satn_stop(ESPState *s)
 {
     s->cmdlen = get_cmd(s, s->cmdbuf);
@@ -544,7 +560,7 @@ static void esp_mem_writeb(void *opaque, target_phys_addr_t addr, uint32_t val)
             break;
         case CMD_SEL:
             DPRINTF("Select without ATN (%2.2x)\n", val);
-            handle_satn(s);
+            handle_s_without_atn(s);
             break;
         case CMD_SELATN:
             DPRINTF("Select with ATN (%2.2x)\n", val);