Skip to contentSkip to conversation

AT91SAM926x Nor Boot

U-Boot Jens Scharsig 4 participants 5 messages Mar 3, 2009 – Mar 4, 2009

lore
Share & tools
lore
#0 lore raw

Hello,

I'm start with a port for a new customer board with NOR-flash only. Our customer don't like use AT91Bootstrap.

I look at the source, but don't found any initialization code for AT91SAM926x.

My question:

Are there any plans or patches which support to use u-boot without AT91Bootstrap? or
Should I do this by myself?

Best regards

J. Scharsig

#1 lore raw
Quoted 5 lines · Jens Scharsig

Hello,

I'm start with a port for a new customer board with NOR-flash only. Our customer don't like use AT91Bootstrap.

Quoted 7 lines

I look at the source, but don't found any initialization code for AT91SAM926x.

My question:

Are there any plans or patches which support to use u-boot without AT91Bootstrap? or
Should I do this by myself?

it was done with Ronetix on the 9263 and 9260

patch are on the ML

They will in the Mainline for the next merge

I've test them on my 9263ek tooo patch fo r the next merge

Best Regards,
J.

#2 lore raw
In reply to Jens Scharsig
Quoted 10 lines · Jens Scharsig

I'm start with a port for a new customer board with NOR-flash only. Our customer don't like use AT91Bootstrap.

I look at the source, but don't found any initialization code for AT91SAM926x.

My question:

Are there any plans or patches which support to use u-boot without AT91Bootstrap? or Should I do this by myself?

We have ported u-boot-v2 to AT91SAM9263, without at91bootstrap. Look in the v2 git repository. The port isn't very mature, but anyway. Patches are welcome.

rsc

Signature · 4 lines
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |
#3 lore raw
In reply to Jens Scharsig
Quoted 11 lines · Jens Scharsig

I'm start with a port for a new customer board with NOR-flash only. Our customer don't like use AT91Bootstrap.

I look at the source, but don't found any initialization code for AT91SAM926x.

My question:

Are there any plans or patches which support to use u-boot without AT91Bootstrap? or
Should I do this by myself?

I have tested a solution based on U-Boot-1.1.5 as modified by Atmel. The
adaptation to booting via NOR flash itself was written by Alessandro Rubini:

http://www.gnudd.com/pub/patches/at91sam9263ek-nor/at91sam9263ek-nor.pdf

Although it is based on old code, the documentation of the problem of booting
from NOR flash on the AT91SAM9263 is worth reading.

Sincerely,

Ken Fuchs