Skip to contentSkip to conversation

SD-Card boot from SPI SD-Card

U-Boot news.gmane.org 2 participants 2 messages Oct 20, 2009 – Oct 21, 2009

lore
Share & tools
lore
#0 lore raw

I have a Coldfire MCF5235 Board and I want to boot the uclinux direct from the sd-card connected to the spi-bus.
Is that possible ?
What do I have to configure ?
Any driver to write ?

Regards
Wilfried

#1 lore raw

Hi Wilfried,

It's possible. Nevertheless, i don't know if the driver is already done. As far as i know all drivers developed doesn't make use of the SPI bus. Just in case, i wrote one for my board and it's working. It could be useful to you.
if you want to add MMC drivers you must define CONFIG_MMC, CONFIG_CMD_FAT and CONFIG_DOS_PARTITION in your configuration file.

Regards,
Ivan Llopard.

2009/10/20 news.gmane.org <[email protected]>:

Quoted 16 lines

I have a Coldfire MCF5235 Board and I want to boot the uclinux direct from the sd-card connected to the spi-bus.
Is that possible ?
What do I have to configure ?
Any driver to write ?

Regards
Wilfried

_______________________________________________
U-Boot mailing list
U-Boot at lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot