LVM skips /dev/hde3 because sysfs tells it not to use it
I had to disable sysfs_scan before pvcreate accepted to use /dev/hde3 on a little MIPS box.
How does LVM decide whether sysfs tells it to use a block device or not? And why would /dev/hde (an internal IDE drive) be presented by sysfs as "not to be used by LVM"?
Stefan
Version of lvm2 userspace?
Version of kernel and relevant config options for sysfs?
Alasdair
Signature · 1 line
[email protected]
Quoted 6 lines · Stefan Monnier
I had to disable
sysfs_scanbefore pvcreate accepted to use/dev/hde3on a little MIPS box.How does LVM decide whether sysfs tells it to use a block device or not? And why would
/dev/hde(an internal IDE drive) be presented by sysfs as "not to be used by LVM"?
It should be possible to use the device unless there is some filter set.
Run the command with debug on (add -vvvv) and you will see which filter disabled the device and why.
I guess you can also hit this "known" problem with
old lvm toolset (<2.02.29) and new kernel with new sysfs layout.
*If* it is this situation you can fix it using one of the following
1) disable sysfs scan
2) upgrade lvm
3) switch CONFIG_SYSFS_DEPRECATED_V2 kernel config on and recompile kernel
Milan
--
[email protected]
Quoted 2 lines
I guess you can also hit this "known" problem with
old lvm toolset (<2.02.29) and new kernel with new sysfs layout.
Yes, sorry about that, that was the culprit. I had done a "apt-get upgrade", but forgot that this box runs Debian "stable". After upgrading lvm2 to the "testing" version of the lvm2 package, the problem disappeared.
Thank you for your help,
Stefan