2.4.19-pre4-ac2 hang at boot with ALI15x3 chipset support
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 4 lines
Quoted 4 lines
Quoted 2 lines
After adding printk calls to
alim15x3.c, it seems to hang during thepci_write_config_byte(isa_dev, 0x79, tmpbyte | 0x02)call on line 588.Does it work if you comemtn that line out ?
James> No, if the line is commented out I get:
James> hda: status error: status=0x58 { DriveReady SeekComplete DataRequest } James> hda: drive not ready for command
I ran into this as well under various kernels including 2.4.18. Try adding:
append="idebus=50"
to the lilo stanza for your kernel.
It seems even after I amputated the offending "write" that causes the lockup, the bus speed was being set to 33MHz instead of 50Mhz. The above solved the problem for me.
I don't need to specifically set idebus in the 2.5.7 version of the driver so I assume something has been corrected in more recent releases.
For anyone else trying to configure the pcg-c1mrx or pcg-c1mv, I'm updating linux configuration document as I work through the setup of the various devices:
http://hale.org/~bhoward/issue_7/pcg-c1mrx.html Bruce
Quoted 5 lines
James> hda: status error: status=0x58 { DriveReady SeekComplete DataRequest } James> hda: drive not ready for command
I ran into this as well under various kernels including 2.4.18. Try adding:
Quoted 7 lines
append="idebus=50"to the lilo stanza for your kernel.
It seems even after I amputated the offending "write" that causes the lockup, the bus speed was being set to 33MHz instead of 50Mhz. The above solved the problem for me.
This worked for me as well -- interesting.
Quoted 4 lines
For anyone else trying to configure the pcg-c1mrx or pcg-c1mv, I'm updating linux configuration document as I work through the setup of the various devices:
http://hale.org/~bhoward/issue_7/pcg-c1mrx.html
Good information there. Oddly enough, I don't need to specify the pci=conf2, though.
Thanks to everyone for the speedy assistance!
- James