saveenv to flash for MPC8360ERDK evaluation board.

Hi,

I am trying to update the u-boot for the LogicPD/Freescale MPC8360ERDK evaluation board and found some problems with saving the environment configurations to flash.

What I found is that in u-boot 1.3.2 the saveenv command works ok, but since u-boot 1.3.3-rc1 (and I suspect later version) the command does not save the environment variable.

from the git-trees, I rolled back /drivers/mtd/cfi_flash.c to the u-boot 1.3.2 version and now the saveenv command seems to work again.

I think some change in there (maybe cmd_set_amd_read_jedec_ids, when info->device_id is populated)
causes the flash writing mishap.

Have anyone else experienced this as well?

Any suggestions are also welcome.

Thank you,

Richard Retanubun

**RuggedCom Inc.
30 Whitmore Road,
Woodbridge, Ontario,
Canada, L4L 7Z4

Hi Richard,

When nobody can answer in a general fashion, it is time to crank up git-bisect(1) and identify the one single commit breaking the functionality. Once you have that located, it may be pretty obvious what is going wrong.

Cheers
Detlev

[1] http://www.kernel.org/pub/software/scm/git/docs/git-bisect.html

Man is a fool, and woman, for tolerating him, is a damned fool
                       -- Mark Twain
--
DENX Software Engineering GmbH,      MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich,  Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-40 Fax: (+49)-8142-66989-80 Email: dzu at denx.de