Skip to contentSkip to conversation

OMAP3: CPUidle: trigger early idle notification call chain

PATCH New Kevin Hilman 1 participant 1 message Sep 23, 2010

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 OMAP3: CPUidle: trigger early idle notification call chain

During the early part of the CPUidle path (state selection by the governer, checking for device activity, etc.) there is no (good) reason to have interrupts disabled.

Therefore, enable interrupts early in the CPUidle path and then trigger the "early" idle notifier call chain after device activity checks and the next power states have been programmed. Interrupts are then (re)disabled after the final state is selected.

Also adjust the timing measurements reported back to the CPUidle core to ensure that time spent in the idle notifiers is included as part of the accounted time.

---
 arch/arm/mach-omap2/cpuidle34xx.c |   33 +++++++++++++++++++++++++++------
 1 files changed, 27 insertions(+), 6 deletions(-)
arch/arm/mach-omap2/cpuidle34xx.c +27 -6
index 0d50b45..6c806a8 100644
@@ -30,6 +30,7 @@
 #include <plat/powerdomain.h>
 #include <plat/clockdomain.h>
 #include <plat/serial.h>
+#include <plat/common.h>
 
 #include "pm.h"
 #include "control.h"
@@ -128,12 +129,14 @@ static int omap3_enter_idle(struct cpuidle_device *dev,
 	/* Used to keep track of the total time in idle */
 	getnstimeofday(&ts_preidle);
 
-	local_irq_disable();
-	local_fiq_disable();
-
 	pwrdm_set_next_pwrst(mpu_pd, mpu_state);
 	pwrdm_set_next_pwrst(core_pd, core_state);
 
+	omap_early_idle_notifier_start();
+
+	local_irq_disable();
+	local_fiq_disable();
+
 	if (omap_irq_pending() || need_resched())
 		goto return_sleep_time;
 
@@ -151,12 +154,14 @@ static int omap3_enter_idle(struct cpuidle_device *dev,
 	}
 
 return_sleep_time:
-	getnstimeofday(&ts_postidle);
-	ts_idle = timespec_sub(ts_postidle, ts_preidle);
-
 	local_irq_enable();
 	local_fiq_enable();
 
+	omap_early_idle_notifier_end();
+
+	getnstimeofday(&ts_postidle);
+	ts_idle = timespec_sub(ts_postidle, ts_preidle);
+
 	return ts_idle.tv_nsec / NSEC_PER_USEC + ts_idle.tv_sec * USEC_PER_SEC;
 }
 
@@ -459,6 +464,21 @@ struct cpuidle_driver omap3_idle_driver = {
 	.owner = 	THIS_MODULE,
 };
 
+static int omap3_idle_prepare(struct cpuidle_device *dev)
+{
+	/*
+	 * Enable interrupts during the early part of the CPUidle path.
+	 * They are later (re)disabled when the final state is selected.
+	 *
+	 * The primary reason for this is to enable non-atomic idle
+	 * notifications to drivers that want to coordinate device
+	 * idle transitions with CPU idle transitions.
+	 */
+	local_irq_enable();
+
+	return 0;
+}
+
 /**
  * omap3_idle_init - Init routine for OMAP3 idle
  *
@@ -482,6 +502,7 @@ int __init omap3_idle_init(void)
 
 	dev = &per_cpu(omap3_idle_dev, smp_processor_id());
 
+	dev->prepare = omap3_idle_prepare;
 	for (i = OMAP3_STATE_C1; i < OMAP3_MAX_STATES; i++) {
 		cx = &omap3_power_states[i];
 		state = &dev->states[count];
Signature · 1 line
1.7.2.1