No subject
8bit ECC correction. So I am not sure this constrain might due to older version controller. Wonder you have any insight on this?
Quoted 19 lines
Denali's document says
For 512B ECC sector size,
ecc.bytes = Ceiling to next word (13 * ecc.strength)
For 1024B ECC sector size,
ecc.bytes = Ceiling to next word (14 * ecc.strength)And
denali_setup_dma_sequence()function
(Why did you rename this function?)
did not work either.
I needed to fix it locally.So bad news is this version itself does not work for me. Good news is I could adjust it locally and confirmed some features worked. (But I think I need more test.)
Quoted 7 lines
So, how will this situation work?
It turned out there are some differences between two Denali hardwares and this driver works only for yours.You merge it first, and (if you don't mind) shall I modify it in a more generic way to run on both hardwares?
Anyway will work for me. I can take your comments and change the driver accordingly too.
Quoted 10 lines
Quoted 2 lines
If you want to run under SPL, there are some patches for that. Let me know if you need that. While for U-Boot, they are working fine. Probably
Thanks for your offering help.
But I am not sure if SOCFPGA and UniPhier can share a SPL nand driver. (Actually I have locally our own Denali driver for SPL.
And I have Denali driver for main U-Boot, which is adjusted for our SoCs, too.
But I don't mind to switch onto your driver if it works for me.)
Oh for SPL, I can use the same driver too. Just that I would need to update the nand_spl_simple.c. The main changes is to use the HW ECC feature instead of getting software calculate and fix the ECC. FYI, the patch I made for SPL is located at
http://rocketboards.org/gitweb/?p=u-boot-socfpga.git;a=commit;h=461a61b8f03d3b690de1f4ff007cd23fb80018a5
Quoted 9 lines
Review
Quoted 4 lines
(quoted diff) +4
-0+#define CONFIG_SYS_NAND_USE_FLASH_BBT +#define CONFIG_SYS_NAND_REGS_BASE SOCFPGA_NAND_REGS_ADDRESS +#define CONFIG_SYS_NAND_DATA_BASE SOCFPGA_NAND_DATA_ADDRESS +#define CONFIG_SYS_NAND_BASE CONFIG_SYS_NAND_REGS_BASEMaybe
#defineCONFIG_SYS_NAND_BASE(SOCFPGA_NAND_DATA_ADDRESS+0x10)
?
For SOCFPGA, the register and data base address have large address space in between them. End of day, it seems its tightly to hardware guys implementation.
Quoted 4 lines
BTW, you changed all
denali->footo denali.foo.
It looks unnecessay to me.
Hmmm.. I suspect this changed when we declare denali as static global.
Thanks
Chin Liang
Quoted 5 lines
Best Regards
Masahiro Yamada