board: Fix mmc pins and remove some no use gpio.
PATCH 1/1 board: Fix mmc pins and remove some no use gpio.
In my board, the sdcard is in mmc2, and using sd2_cdn to detect.
--- board/samsung/tiny4412/tiny4412.c | 9 +++++---- 1 file changed, 5 insertions(+), 4 deletions(-)
(quoted diff) +0 -0
b/board/samsung/tiny4412/tiny4412.c
index 4f5bfbd..f969866 100644
board/samsung/tiny4412/tiny4412.c +5 -4
@@ -41,6 +41,8 @@ static void check_hw_revision(void)s5p_gpio_cfg_pin (&gpio2->m1, i,GPIO_INPUT );/* GPM1[5:2]: HW_REV[3:0] */ +/*In my board, those pins are used for camera*/ +/* GMP0[0:7] and GPM1[0:3] */ for (i =2 ; i <6 ; i++) {s5p_gpio_cfg_pin (&gpio2->m1, i,GPIO_INPUT );s5p_gpio_set_pull (&gpio2->m1, i,GPIO_PULL_NONE );
@@ -87,9 +89,7 @@ static void board_external_gpio_init(void)* if that pin set as input then that floated */ -s5p_gpio_set_pull (&gpio2->x1,5 ,GPIO_PULL_NONE );/* IF_PMIC_IRQ*/ s5p_gpio_set_pull (&gpio2->x3,5 ,GPIO_PULL_NONE );/* OK_KEY */ -s5p_gpio_set_pull (&gpio2->x3,7 ,GPIO_PULL_NONE );/* HDMI_HPD */ }#ifdef CONFIG_SYS_I2C_INIT_BOARD
@@ -114,6 +114,7 @@ static void board_init_i2c(void)int board_early_init_f (void ) { +/*pull up led*/ gpio2 = (struct exynos4x12_gpio_part2 *)EXYNOS4X12_GPIO_PART2_BASE ;s5p_gpio_cfg_pin (&gpio2->m4,1 ,GPIO_INPUT );s5p_gpio_set_pull (&gpio2->m4,1 ,GPIO_PULL_NONE );
@@ -206,9 +207,9 @@ int board_mmc_init(bd_t *bis)/* * Check the T-flash detect pin -* GPX3[4] T-flash detect pin +* GPK2[2] T-flash detect pin */ -if (!s5p_gpio_get_value (&gpio2->x3,4 )) { +if (!s5p_gpio_get_value (&gpio2->k2,2 )) { err2 =exynos_pinmux_config (PERIPH_ID_SDMMC2 ,PINMUX_FLAG_NONE );if (err2)debug ("SDMMC2 not configured\n" );
Signature · 1 line
1.8.4.rc3