AT91: Add flexibity board support
PATCH 1/1 AT91: Add flexibity board support
Signed-off-by Maxim Osipov <[email protected]>
--- arch/arm/mach-at91/Kconfig | 6 ++ arch/arm/mach-at91/Makefile | 1 + arch/arm/mach-at91/board-flexibity.c | 164 ++++++++++++++++++++++++++++++++++ 3 files changed, 171 insertions(+), 0 deletions(-) create mode 100644 arch/arm/mach-at91/board-flexibity.c
arch/arm/mach-at91/Kconfig +6 -0
@@ -248,6 +248,12 @@ config MACH_CPU9260 Select this if you are using a Eukrea Electromatique's CPU9260 Board <http://www.eukrea.com/> +config MACH_FLEXIBITY + bool "Flexibity Connect board" + help + Select this if you are using Flexibity Connect board + <http://www.flexibity.com> + endif # ----------------------------------------------------------
arch/arm/mach-at91/Makefile +1 -0
@@ -46,6 +46,7 @@ obj-$(CONFIG_MACH_USB_A9260) += board-usb-a9260.o obj-$(CONFIG_MACH_QIL_A9260) += board-qil-a9260.o obj-$(CONFIG_MACH_AFEB9260) += board-afeb-9260v1.o obj-$(CONFIG_MACH_CPU9260) += board-cpu9krea.o +obj-$(CONFIG_MACH_FLEXIBITY) += board-flexibity.o # AT91SAM9261 board-specific support obj-$(CONFIG_MACH_AT91SAM9261EK) += board-sam9261ek.o
arch/arm/mach-at91/board-flexibity.c new file +164 -0
164 lines not on this page · raw message
Signature · 1 line
1.7.1