pxa3xx_nand: add polling mode support
Subsystems (2)
PATCH 1/1 pxa3xx_nand: add polling mode support
Add polling mode to facilitate debugging.
--- drivers/mtd/nand/pxa3xx_nand.c | 119 +++++++++++++++++++++++++++------------- 1 files changed, 80 insertions(+), 39 deletions(-)
drivers/mtd/nand/pxa3xx_nand.c +6 -1
@@ -26,9 +26,10 @@#include <mach/dma.h> #include <plat/pxa3xx_nand.h> -#define CHIP_DELAY_TIMEOUT (2 * HZ/10) +#define CHIP_DELAY_TIMEOUT (100 * HZ/10)#define NAND_STOP_DELAY (2 * HZ/50)#define PAGE_CHUNK_SIZE (2048) +#define OOB_CHUNK_SIZE (64)#define BCH_THRESHOLD (8)#define CMD_POOL_SIZE (5)#undef PXA3XX_NAND_DEBUG
@@ -298,6 +299,10 @@ static int use_dma = 1;module_param (use_dma, bool,0444 );MODULE_PARM_DESC (use_dma,"enable DMA for data transfering to/from NAND HW" ); +static int use_polling =0 ; +module_param (use_polling, bool,0444 ); +MODULE_PARM_DESC (use_polling,"Use full polling mode" ); +static int naked_cmd_support =0 ;module_param (naked_cmd_support, bool,0444 ); MODULE_PARM_DESC(naked_cmd_support, "Whether the controller support
using naked command set");
@@ -329,7 +334,7 @@ static struct pxa3xx_nand_flash __devinitdata builtin_flash_types[] = {
{ 0xd3ec, 128, 2048, 8, 8, ECC_BCH, 4096, \
{ 0, 10, 0, 20, 40, 30, 40, 11123, 0, 110, 10, }, },
{ 0xd7ec, 128, 4096, 8, 8, ECC_BCH, 8192, \
- { 0, 10, 0, 20, 40, 30, 40, 11123, 0, 110, 10, }, },
+ { 0, 10, 0, 20, 40, 30, 40, 25000, 0, 110, 10, }, },
{ 0xa12c, 64, 2048, 8, 8, ECC_HAMMIN, 1024, \
{ 0, 10, 25, 15, 25, 15, 30, 25000, 0, 60, 10, }, },
{ 0xb12c, 64, 2048, 16, 16, ECC_HAMMIN, 1024, \
@@ -569,7 +574,8 @@ static void pxa3xx_nand_start(struct pxa3xx_nand *nand)
info = nand->info[nand->chip_select];
ndcr = info->reg_ndcr;
- ndcr |= nand->use_dma ? NDCR_DMA_EN : NDCR_STOP_ON_UNCOR; + ndcr |= nand->use_dma ? NDCR_DMA_EN : 0; + ndcr |= use_polling ? NDCR_INT_MASK : 0; ndcr |= NDCR_ND_RUN;
switch (nand->use_ecc) {
@@ -764,9 +770,8 @@ static void pxa3xx_nand_data_dma_irq(int channel, void *data)
nand_writel(nand, NDSR, NDSR_WRDREQ | NDSR_RDDREQ);
}
-static irqreturn_t pxa3xx_nand_irq(int irq, void *devid)
+static int pxa3xx_nand_transaction(struct pxa3xx_nand *nand)
{
- struct pxa3xx_nand *nand = devid;
struct pxa3xx_nand_info *info;
unsigned int status, is_completed = 0, cs, cmd_seqs, ndcb1, ndcb2; unsigned int ready, cmd_done, page_done, badblock_detect;
@@ -780,8 +785,10 @@ static irqreturn_t pxa3xx_nand_irq(int irq, void *devid)
cmd_seqs = info->cmd_seqs;
status = nand_readl(nand, NDSR);
- DBG_NAND(if (status != 0)
- printk("\t\t==cmd seqs %x, status %x, cs %x\n", cmd_seqs, status, cs));
+ if (!status)
+ return 0;
+ DBG_NAND(printk("\t\t==cmd seqs %x, status %x, cs %x\n",
+ cmd_seqs, status, cs));
nand->bad_count = (status & NDSR_ERR_CNT_MASK) >> 16;
if (status & NDSR_DBERR)
nand->retcode = ERR_DBERR;
@@ -791,7 +798,7 @@ static irqreturn_t pxa3xx_nand_irq(int irq, void *devid)
nand->state |= STATE_DATA_PROCESSING;
/* whether use dma to transfer data */
- if (nand->use_dma) {
+ if (nand->use_dma && !use_polling) {
disable_int(nand, NDCR_INT_MASK); start_data_dma(nand, nand->state & STATE_IS_WRITE); goto NORMAL_IRQ_EXIT;
@@ -805,13 +812,20 @@ static irqreturn_t pxa3xx_nand_irq(int irq, void *devid)
if (status & ready) {
nand->state |= STATE_READY;
if (info->wait_ready[cmd_seqs]) {
- enable_int(nand, NDCR_WRCMDREQM);
+ if (!use_polling)
+ enable_int(nand, NDCR_WRCMDREQM | NDCR_CS0_CMDDM
+ | NDCR_CS1_CMDDM);
if (cmd_seqs == info->total_cmds)
is_completed = 1;
}
}
if (status & cmd_done) {
nand->state |= STATE_CMD_DONE;
+ if (info->wait_ready[cmd_seqs] && !(nand->state & STATE_READY)) {
+ status &= ~cmd_done;
+ if (!use_polling)
+ disable_int(nand, NDCR_CS0_CMDDM | NDCR_CS1_CMDDM);
+ }
if (cmd_seqs == info->total_cmds && !info->wait_ready[cmd_seqs])
is_completed = 1;
}
@@ -819,7 +833,8 @@ static irqreturn_t pxa3xx_nand_irq(int irq, void *devid)
if (status & NDSR_WRCMDREQ) {
status &= ~NDSR_WRCMDREQ;
if (info->wait_ready[cmd_seqs] && !(nand->state & STATE_READY)) {
- disable_int(nand, NDCR_WRCMDREQM);
+ if (!use_polling)
+ disable_int(nand, NDCR_WRCMDREQM);
goto IRQ_FORCE_EXIT;
}
@@ -849,12 +864,36 @@ static irqreturn_t pxa3xx_nand_irq(int irq, void *devid)
IRQ_FORCE_EXIT:
/* clear NDSR to let the controller exit the IRQ */ nand_writel(nand, NDSR, status);
+NORMAL_IRQ_EXIT:
+ return is_completed;
+}
+
+static irqreturn_t pxa3xx_nand_irq(int irq, void *devid)
+{
+ struct pxa3xx_nand *nand = devid;
+ int is_completed;
+
+ is_completed = pxa3xx_nand_transaction(nand);
if (is_completed)
complete(&nand->cmd_complete);
-NORMAL_IRQ_EXIT:
+
return IRQ_HANDLED;
}
+static int pxa3xx_nand_polling(struct pxa3xx_nand *nand, unsigned long timeout) +{
+ int i, ret = 0;
+
+ for (i = 0; i < timeout; i++) {
+ ret = pxa3xx_nand_transaction(nand);
+ if (ret)
+ break;
+ udelay(5);
+ }
+
+ return ret;
+}
+
static inline int is_buf_blank(uint8_t *buf, size_t len)
{
for (; len > 0; len--)
@@ -1107,8 +1146,11 @@ static void pxa3xx_nand_cmdfunc(struct mtd_info *mtd, unsigned command,
nand->state |= STATE_CMD_PREPARED; pxa3xx_nand_start(nand);
- ret = wait_for_completion_timeout(&nand->cmd_complete,
- CHIP_DELAY_TIMEOUT);
+ if (!use_polling)
+ ret = wait_for_completion_timeout(&nand->cmd_complete,
+ CHIP_DELAY_TIMEOUT);
+ else
+ ret = pxa3xx_nand_polling(nand, CHIP_DELAY_TIMEOUT);
if (!ret) {
printk(KERN_ERR "Wait time out!!!\n"); nand_error_dump(nand);
@@ -1229,31 +1271,30 @@ static void pxa3xx_nand_config_flash(struct pxa3xx_nand_info *info,
ndcr |= (f->dfc_width == 16) ? NDCR_DWIDTH_C : 0;
switch (f->page_per_block) {
- case 32:
- ndcr |= NDCR_PG_PER_BLK(0x0);
- break;
- case 128:
- ndcr |= NDCR_PG_PER_BLK(0x1);
- break;
- case 256:
- ndcr |= NDCR_PG_PER_BLK(0x3);
- break;
- case 64:
- default:
- ndcr |= NDCR_PG_PER_BLK(0x2);
- break;
+ case 32:
+ ndcr |= NDCR_PG_PER_BLK(0x0);
+ break;
+ case 128:
+ ndcr |= NDCR_PG_PER_BLK(0x1);
+ break;
+ case 256:
+ ndcr |= NDCR_PG_PER_BLK(0x3);
+ break;
+ case 64:
+ default:
+ ndcr |= NDCR_PG_PER_BLK(0x2);
+ break;
}
switch (f->page_size) {
- case 512:
- ndcr |= NDCR_PAGE_SZ(0x0);
- break;
- case 2048:
- default:
- ndcr |= NDCR_PAGE_SZ(0x1);
- ndcr |= NDCR_FORCE_CSX;
- break;
-
+ case 512:
+ ndcr |= NDCR_PAGE_SZ(0x0);
+ break;
+ case 2048:
+ default:
+ ndcr |= NDCR_PAGE_SZ(0x1);
+ ndcr |= NDCR_FORCE_CSX;
+ break;
}
ndcr |= NDCR_RD_ID_CNT(info->read_id_bytes);
@@ -1264,11 +1305,11 @@ static void pxa3xx_nand_config_flash(struct pxa3xx_nand_info *info,
pxa3xx_nand_set_timing(info, &f->timing, show_timing);
}
-/* the maximum possible buffer size for large page with OOB data
- * is: 2048 + 64 = 2112 bytes, allocate a page here for both the
- * data buffer and the DMA descriptor
+/* the max buff size should be large than
+ * the largest size of page of NAND flash
+ * that currently controller support
*/
-#define MAX_BUFF_SIZE PAGE_SIZE
+#define MAX_BUFF_SIZE ((PAGE_CHUNK_SIZE + OOB_CHUNK_SIZE) * 2) +sizeof(struct pxa_dma_desc)
static struct nand_ecclayout hw_smallpage_ecclayout = {
.eccbytes = 6,
Signature · 1 line
1.5.6.5