add bcmring mtd nand driver support
PATCH 1/1 add bcmring mtd nand driver support
Add mtd umi driver for bcmring arm arch.
Add header files, register definition files,
add entry in Kconfig and Makefile.
remove superfluous comments from bcm nand driver
use platform resource
Signed-off-by Leo Hao Chen <[email protected]>
--- arch/arm/mach-bcmring/arch.c | 10 + arch/arm/mach-bcmring/include/mach/reg_nand.h | 66 +++ arch/arm/mach-bcmring/include/mach/reg_umi.h | 237 ++++++++++ drivers/mtd/nand/Kconfig | 16 + drivers/mtd/nand/Makefile | 1 + drivers/mtd/nand/bcm_umi_bch.c | 213 +++++++++ drivers/mtd/nand/bcm_umi_nand.c | 580 +++++++++++++++++++++++++ drivers/mtd/nand/nand_bcm_umi.c | 149 +++++++ drivers/mtd/nand/nand_bcm_umi.h | 358 +++++++++++++++ 9 files changed, 1630 insertions(+), 0 deletions(-) create mode 100644 arch/arm/mach-bcmring/include/mach/reg_nand.h create mode 100644 arch/arm/mach-bcmring/include/mach/reg_umi.h create mode 100644 drivers/mtd/nand/bcm_umi_bch.c create mode 100644 drivers/mtd/nand/bcm_umi_nand.c create mode 100644 drivers/mtd/nand/nand_bcm_umi.c create mode 100644 drivers/mtd/nand/nand_bcm_umi.h
arch/arm/mach-bcmring/arch.c +10 -0
@@ -76,9 +76,19 @@ static struct ctl_table bcmring_sysctl_reboot[] = { {} }; +static struct resource nand_resource[] = { + [0 ] = { + .start =MM_ADDR_IO_NAND , + .end =MM_ADDR_IO_NAND +0x1000 -1 , + .flags =IORESOURCE_MEM , + }, +}; +static struct platform_device nand_device = { .name ="bcm-nand" , .id =-1 , + .resource = nand_resource, + .num_resources =ARRAY_SIZE (nand_resource), };static struct platform_device *devices[]__initdata = {
arch/arm/mach-bcmring/include/mach/reg_nand.h new file +66 -0
66 lines not on this page · raw message
arch/arm/mach-bcmring/include/mach/reg_umi.h new file +237 -0
237 lines not on this page · raw message
drivers/mtd/nand/Kconfig +16 -0
@@ -203,6 +203,22 @@ config MTD_NAND_S3C2410_CLKSTOP when the is NAND chip selected or released, but will save approximately 5mA of power when there is nothing happening. +config MTD_NAND_BCM_UMI + tristate "NAND Flash support for BCM Reference Boards" + depends on ARCH_BCMRING && MTD_NAND + help + This enables the NAND flash controller on the BCM UMI block. + + No board specfic support is done by this driver, each board + must advertise a platform_device for the driver to attach. + +config MTD_NAND_BCM_UMI_HWCS + bool "BCM UMI NAND Hardware CS" + depends on MTD_NAND_BCM_UMI + help + Enable the use of the BCM UMI block's internal CS using NAND. + This should only be used if you know the external NAND CS can toggle. + config MTD_NAND_DISKONCHIP tristate "DiskOnChip 2000, Millennium and Millennium Plus (NAND reimplementation) (EXPERIMENTAL)" depends on EXPERIMENTAL
drivers/mtd/nand/Makefile +1 -0
@@ -42,5 +42,6 @@ obj-$(CONFIG_MTD_NAND_SOCRATES) += socrates_nand.o obj-$(CONFIG_MTD_NAND_TXX9NDFMC) += txx9ndfmc.o obj-$(CONFIG_MTD_NAND_W90P910) += w90p910_nand.o obj-$(CONFIG_MTD_NAND_NOMADIK) += nomadik_nand.o +obj-$(CONFIG_MTD_NAND_BCM_UMI) += bcm_umi_nand.o nand_bcm_umi.o nand-objs := nand_base.o nand_bbt.o
drivers/mtd/nand/bcm_umi_bch.c new file +213 -0
213 lines not on this page · raw message
drivers/mtd/nand/bcm_umi_nand.c new file +580 -0
580 lines not on this page · raw message
drivers/mtd/nand/nand_bcm_umi.c new file +149 -0
149 lines not on this page · raw message
drivers/mtd/nand/nand_bcm_umi.h new file +358 -0
358 lines not on this page · raw message
Signature · 1 line
1.6.0.6