Skip to contentSkip to conversation

fsl_esdhc: fix PIO mode transfers

PATCH New Ira W. Snyder 1 participant 1 message Dec 16, 2011 MMC, SD and SDIO

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 fsl_esdhc: fix PIO mode transfers

The pointer to the registers used to control the Freescale MMC controller is not initialized correctly when using PIO mode. This is fixed by initializing the pointer identically to all other usage in the driver.

Examining the commit history shows that this was broken at introduction due to a code change in upstream U-Boot to support the mx51 processor family.

---

Tested on the P2020COME board with PIO explicitly enabled via:
#define CONFIG_SYS_FSL_ESDHC_USE_PIO

 drivers/mmc/fsl_esdhc.c |    3 ++-
 1 files changed, 2 insertions(+), 1 deletions(-)
drivers/mmc/fsl_esdhc.c +2 -1
index ec953f0..b56ddc65 100644
@@ -113,7 +113,8 @@ uint esdhc_xfertyp(struct mmc_cmd *cmd, struct mmc_data *data)
 static void
 esdhc_pio_read_write(struct mmc *mmc, struct mmc_data *data)
 {
-	struct fsl_esdhc *regs = mmc->priv;
+	struct fsl_esdhc_cfg *cfg = mmc->priv;
+	struct fsl_esdhc *regs = (struct fsl_esdhc *)cfg->esdhc_base;
 	uint blocks;
 	char *buffer;
 	uint databuf;
Signature · 1 line
1.7.3.4