Skip to contentSkip to conversation

unshaping telnet

LARTC Fabian Gervan 1 participant 1 message Sep 29, 2001

lore
Share & tools
lore
#0 lore raw

Hello

I have this setup, it work fine, but i can't telnet from any client to
the linux server without trafic shaping:
--cut--
tc qdisc add dev eth1 root handle 1: cbq bandwidth 10Mbit avpkt 1000
tc class add dev eth1 parent 1:0 classid 1:1 cbq bandwidth 100Mbit rate 100Mbit allot 1514 weigh

tc class add dev eth1 parent 1:1 classid 1:100 cbq bandwidth 100Mbit rate 64kbit allot 1514 weight 6Kbit prio 5 maxburst 12 avpkt 1000 bounded tc class add dev eth1 parent 1:100 classid 1:102 cbq bandwidth 100Mbit rate 32kbit allot 1514 weight 3Kbit prio 5 maxburst 6 avpkt 1000 borrow tc class add dev eth1 parent 1:100 classid 1:103 cbq bandwidth 100Mbit rate 32kbit allot 1514 weight 3Kbit prio 5 maxburst 6 avpkt 1000 borrow

tc qdisc add dev eth1 parent 1:102 sfq quantum 1514b perturb 15 tc qdisc add dev eth1 parent 1:103 sfq quantum 1514b perturb 15

tc filter add dev eth1 parent 1:0 protocol ip prio 25 u32 match ip dst 10.0.0.2/32 flowid 1:102
tc filter add dev eth1 parent 1:0 protocol ip prio 25 u32 match ip dst 10.0.0.3/32 flowid 1:103
--cut--
server (10.0.0.1)

      64kbit (bounded)
             32kbit (borrow)-  PC1   (10.0.0.2)
             32kbit-(borrow)-  PC2   (10.0.0.3)

what I should add/change to make a telnet from pc1 or pc2 to server, without trafic shaping, or minimal shapping?

Regards, Fabian.

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/