Skip to contentSkip to conversation

formula for minimum latency of connections on a loaded link

LARTC bert hubert 2 participants 3 messages Feb 16, 2002

lore
Share & tools
lore
#0 lore raw

I saw some discussions regarding QoS settings not influencing latency on a loaded link, or not influencing it enough.

The following formula may help clarify things:

                     avgpacketbytes*5000

msavglatencyadded= -------------------
bpsoflink

So for a 56k6 modem, this boils down to 132ms on average *added* to the existing latency. Why is this so? There is a baseline latency, which is a given. Then there is a queue of packets that are destined to go out before yours.

In the absence of QoS control, that queue may be huge. Perfect QoS would lead to a zero sized queue ahead of your packet. However, as packets can't be subdivided or interrupted (generally), your modem will already be busy sending one packet when yours gets queued for transmission.

On average, this packet will be halfway when your packet arrives. So, the additional latency in msec is the amount of time it takes your link to transmit half a typical packet.

The peak additional latency is twice that calculated above, so you could also see 264ms additional delay.

This is an artifact of having packets which take a long time to transmit. You can ameliorate the problem by setting a lower MTU to make sure your packets go out quickly.

Regards.

bert

Signature · 7 lines
http://www.PowerDNS.com          Versatile DNS Software & Services
http://www.tk                              the dot in .tk
Netherlabs BV / Rent-a-Nerd.nl           - Nerd Available -
Linux Advanced Routing & Traffic Control: http://ds9a.nl/lartc
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/
#2 lore raw
In reply to bert hubert
Quoted 7 lines · Martin Devera
Quoted 3 lines
                     avgpacketbytes*5000

msavglatencyadded= -------------------
bpsoflink

Hi Bert,

where came the 5000 from ? I'd expect 1000 here ... :-o

'bps' should be read as 'bits per second'. So:

                      avgpacketbytes*10*1000

msavglatencyadded = ---------------------- * 0.5
bitspersecondoflink

And this becomes '*5000'.

Regards,

bert

Signature · 7 lines
http://www.PowerDNS.com          Versatile DNS Software & Services
http://www.tk                              the dot in .tk
Netherlabs BV / Rent-a-Nerd.nl           - Nerd Available -
Linux Advanced Routing & Traffic Control: http://ds9a.nl/lartc
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/