Skip to contentSkip to conversation

bridge question (+homepna)

LARTC Bill Williamson 1 participant 1 message Apr 22, 2002

lore
Share & tools
lore
#0 lore raw

Okay, right now I have: (this may be really bad ascii)

       dsl
        |(eth0)
      router
        |(eth1)
    ---hub---
    /        \
hpnabridge   ethernet hub
 |  |  |       |   |   |
computers      computers
(hpna cards)    (ethernet cards) 

I have hpna drivers working great for linux, so getting that working/etc is no biggie.

I wanna switch to:

       dsl
        |(eth0)
      router

(eth2)/ \(eth1)

eth1 would be ethernet as is now, eth2 would be a homepna card.

Right now, since i'm using a hardware hpna->ethernet bridge, the homepna clients can see the rest of the network fine (same subnet, can use network neighborhood/etc). How can I accomplish this with my new proposed setup?

At first I thought i would just run dhcpd on both interfaces on different subnets, but then I remebered that a. network neighborhood and b. lan games might not work (many games require only 1 cdkey if you play over lan instead of the internet, and it determines that by being on the same subnet as the server).

Suggestions/etc?
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/