Skip to contentSkip to conversation

cbq (root class) rate problem]

LARTC Leandro Stasi 2 participants 2 messages May 7, 2002

lore
Share & tools
lore
#0 lore raw
Quoted 13 lines · Stef Coene
Quoted 13 lines

I did a workaround by creating an extra class with root class as parent and isolated,bounded

But I don't like to have extra classes just becuse I can control root class.

tc qdisc add dev eth0 root handle 10:0 cbq bandwidth 10mbit avpkt 1000 cell 8

tc class add dev eth0 parent 10:0 classid 10:1 cbq bandwidth 10mbit rate 50kbit allot 1514 cell 8 maxburst 20 avpkt 1000 isolated bounded

Quoted 7 lines
Quoted 6 lines

tc class add dev eth0 parent 10:1 classid 10:10 cbq bandwidth 10mbit rate 25kbit allot 1514 cell 8 maxburst 20 avpkt 1000 sharing borrow

tc class add dev eth0 parent 10:1 classid 10:11 cbq bandwidth 10mbit rate 25kbitallot 1514 cell 8 maxburst 20 avpkt 1000 sharing borrow

This is the way you should do it. That extra class is no problem.

You can

Quoted 1 line

remove the sharing and borrow parameter if you want. They are on by

default.

Quoted 7 lines

Also provide a weight parameter (I take weight = rate/2) and attach the filters to the root qdisc and point them direclty to the end class.

Stef

It is useless to attach a qdisc (like sfq) to the extra class?

What is the difference between attaching the filter to the root qdisc or to the leaf classes?

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 6 lines
Quoted 4 lines

Also provide a weight parameter (I take weight = rate/2) and attach the filters to the root qdisc and point them direclty to the end class.

Stef

It is useless to attach a qdisc (like sfq) to the extra class?

No. Default, the classes uses a PRIO qdisc (or FIFO, I'm not sure) to send the data. And you can replace it with SFQ.

Quoted 2 lines

What is the difference between attaching the filter to the root qdisc or to the leaf classes?

If tried it a few times. And the result was that I had to supply the weight parameter and uses filters attached to the root qdisc to get the results like I wanted.

Stef

Signature · 7 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
     #lartc @ irc.openprojects.net
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/