IMQ
Hi !
Quoted 5 lines · Odri Kornel
Hi,
I'm trying to set up a QoS over two logical devices. Imq would be great, but my problem is that it's using POSTROUTING rules and I'm already using SNAT wich also requires it.
I don't see where the problem is, NAT is an iptables table, IMQ is a network device. The IMQ iptables target just marks the packet in POSTROUTING to be enqueued, the actual enqueueing/dequeueing happens later (after all tables have been passed). The only thing you have to be aware of is that for outgoing packets the mangle table (marking) will see the original source ip while any u32/whatever filters attached to the imq device will get the packets already SNATed, but thats just like with regular network devices.
Bye,
Patrick
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Hi.
Quoted 6 lines · Odri Kornel
Thank you for your quick answer.
My problem was that although imq is a device it is called via iptables like a table just as snat. As far as I know if iptables finds a matching rule, it jumps out of the chain, and does not process the other rules. Is this where I made a mistake? I haven't found any description about this...
Yes this is not true. If a packet is not explicit dropped / accepted it continues traversal. Think about the MARK target, in fact the IMQ target is just a modified MARK target.
Also, the imq device is not called via iptables, iptables is just used for specifying that the current packet should pass through the imq device at a later point. The IMQ device feeds itself through netfilter hooks, so in theory you could f.e. mark all IPX/whatever packets somewhere during their processing and they would pass the imq device, too.
Quoted 10 lines
So, youre saying, that the packet will be processed trough the other postrouting rules after being marked by the mangle rule?
For ex.:
iptables -t mangle -A POSTROUTING -o eth0 -j IMQ iptables -t mangle -A POSTROUTING -o ipsec0 -j IMQ iptables -t nat -A POSTROUTING -j SNAT ...
This should work?
Yes.
Bye,
Patrick
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/