Skip to contentSkip to conversation

Problems with CBQ.init + aliased IP's

LARTC José de Paula Eufrásio =?iso-8859-1?Q?_J=F 1 participant 1 message May 21, 2002

lore
Share & tools
lore

José de Paula Eufrásio =?iso-8859-1?Q?_J=F

#0 lore raw

Hello

I made a set of CBQ rules using the cbq.init script, but i got one aliased interface eth1:0 that is the gateway for a machine in a subnet...

I put a rule for this machine in the eth1 but seems that CBQ isn't limiting the traffic for it, and in the config files I can't put eth1:0 as the interface...

note that there's a route to all traffic going to the especific IP to pass for the eth1:0 interface.

sniffing the eth1:0 with tcpdump i can see packages going from the net to the IP, and sniffing the eth0 i can see the packets coming. I manage to limite the outgoing traffic putting the rule in eth0, but the traffic incoming to the IP no, because it's exiting by a aliased interface.

There's a solution for it?

[]s
coredump

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/