Problem with windows routing
Hi,
I have little problem with windows computers and two routers on one
subnet. One router is to route packets to the internet and the second to route packets to other LANs. By dhcpd, windows machines get the default gateway the LAN router. But they change their route tables because some packets go of course to internet. I turned off sending redirects on both routers but windows do it on their own I think. The problem is when I want to connect from the other LAN to this segment, the comupters doesn't answer, however ping works well. (Because the packet comes from LAN router but windows has the default route to the inet router and the packet gets lost) When I set the route table on some of those windows machines manually it works fine but that's thing I cannot do by dhcpd. Unfortunately, dhcpd is the only way to configure all those f*c*i*g (;-)) windows.
One solution is to set mask of the internet router to something else so
that the windows machines wouldn't see it and set default route to the LAN router. On the LAN router set virtual interface to see the internet router etc. etc. In addition to this complicated solution, the packets would double the bandwidth on the segment :-(
Any idea?
Thanks very much,
Vladimir Trebicky
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 2 lines
I turned off sending redirects on both routers
but windows do it on their own I think
Why?
Quoted 2 lines
Because the packet comes from LAN router but windows has the default route to the inet router and the packet gets lost
Your internet router does NAT I think? Then it seems logical..
Quoted 2 lines
when I set the route table on some of those windows machines manually it works fine but that's thing I cannot do by dhcpd
Simplest solution is re-enabling redirects on the inet router (I don't see the problem only that the windows box builds a big route table with many single routes)
Second simple solution is adding the routes to the second LAN manually on the windows boxes and use the -p switch... With -p they become permanent routes even if you restart the machine.
Niels.
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
You discovered it :-) Probably it is the NAT ! When the packet returns via the inet router it gets someone else's ip.
So I must set in iptables on the inet router not to SNAT packets not coming to inet ;-)
Thanks,
Vladimir Trebicky
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/