Skip to contentSkip to conversation

which interface to shape for ppoe?

LARTC Mattt 1 participant 1 message Oct 6, 2002

lore
Share & tools
lore

Mattt

author
#0 lore raw

I think I understand what's going on, thanks to a small mistake ;-)

I needed to add a 5th nic to the gateway box - this new nic was an identical mate for another isa in there, so I modified the module options accordingly.

So, after 10 minutes of trying to figure out why the DSL device was unwilling to talk to, well, anything - it occurred to me that the new card was the next address up, hence the modem is *now* on eth4...

I modified the wshaper and re-ran it. Next few hours are spent wondering why the path between the half-dead server and the replacement is at, like, DSL speeds :-/

Today, I've dug deeper, and found that eth3 was *still* being shaped (even though it's now part of a 3-if bridge), and indeed, some bands had seen traffic!!

However, eth4 was also now shaped, with the same script (makes sense after reading wshaper again), but the bands are *not* seeing traffic, even after limiting to half the DSL line speed and upping a 6mb file to a remote site via scp...

I'm now almost totally convinced that traffic is eluding the filters because it's *actually* traffic out ppp0 (I'm currently using the Debian userland pppoe thingy), and I'm tc'ing on eth4 (to which the DSL device is attached). However earlier in the game, when I tried to shape ppp0, the kernel would reliably oops after about a minute.

What am I doing wrong?

Signature · 10 lines
Cheers,
 Mattt.                      icq   : 117539757 
 aboveNetworks               www   : www.above.nq4u.net
 [email protected]        jabber: [email protected]
     
	 What's got four legs and an arm?  A happy Pit Bull...

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/