Skip to contentSkip to conversation

Policing

LARTC Rajiv Ghai 3 participants 3 messages Dec 2, 2002 – Oct 26, 2004

lore
Share & tools
lore

Rajiv Ghai

author
#0 lore raw

HI
I have read the advanced routing and traffic control and have a question on policing. I am using RH 7.1 and have two interfaces, one eth0 to the internet 256K and one eth1 to some 50 students on a LAN connected via a 2 MBPS wireless link. Now it seems that when the wireless link goes down for a few seconds, there is a burst of incoming traffic and my linux box crashes (my theory). How do I configure policing to limit the traffic when the link comes up again ?
Thanks
Rajiv
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 8 lines · Rajiv Ghai

HI
I have read the advanced routing and traffic control and have a question on policing. I am using RH 7.1 and have two interfaces, one eth0 to the internet 256K and one eth1 to some 50 students on a LAN connected via a 2 MBPS wireless link. Now it seems that when the wireless link goes down for a few seconds, there is a burst of incoming traffic and my linux box crashes (my theory). How do I configure policing to limit the traffic when the link comes up again ?

I'm not sure if policing will solve your problem.
To police incoming traffic, you need to add an ingress qdisc. And 1 filter that matches all traffic and you need to configure the filter with a policer. If the incoming rate exceeds the rate of the policer, all incoming packets above that rate are dropped.
I have no examples to show you, but if you download the iproute2 source, you will find some examples in the examples directory.

Stef

Signature · 8 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
     #lartc @ irc.oftc.net

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
#2 lore raw
In reply to Rajiv Ghai

My attempts to configure policing are stopping incoming traffic all together.

From the LARTC HOWTO, I gather that the following lines should limit
incoming traffic on eth0 to 32kbit by dropping packets above this threshold:

	tc qdisc add dev eth0 ingress

	tc filter add dev eth0 parent ffff: protocol ip u32 \
		match u8 0x0 0x0 \
		police rate 32kbit burst 10k drop \
		classid :1

Instead, they stop all incoming traffic. From tcpdump, I can tell that packets are outgoing by this interface, but none are incomming.

I'm running a custom 2.4.27 kernel & Debian unstable; iproute 20010824-13.1.

Can anyone offer some insight?

Thanks!

Jack

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/