Skip to contentSkip to conversation

udp broadcast over ipsec

LARTC listuser 2 participants 2 messages Dec 26, 2002 – Dec 27, 2002

lore
Share & tools
lore

listuser

author
#0 lore raw

Hello all,

I am configuring a vpn between freeswan and windows 2000. I am following the steps at http://www.jacco2.dds.nl/networking/win2000xp-freeswan.html, to get the VPN up and running. using this I have a ppp tunnel between windows and linux, which is inside a l2tp tunnel which is again encrypted by IPSec. (the url gives the configuration in detail and I have followed it exactly)

Now the windows gets the proper ip and every thing is working as it should except udp brpadcast, which is the reason why I set up the vpn (for a stock exchange, where the quots data comes as b'cast). Since the windows is having an ip in the same network their is no reason why B'cast should not work.

I searched a lot for any pointer but I found only one MS Knowledge Base Article No. 253169 which says that B'cast is not supported in Windows IPSec. Is this the case with Linux also. Is their any thing that can be done to send B'cast also. Any help here will be much appriciated. I am working though Xmas to get this working :(

raj

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

I personally haven't tried setting it up, but I think GRE tunnels may be what you might try using. Either IPSec inside GRE or GRE inside IPSec.

GRE tunnels (if I read it correctly) should support broadcasting.

Quoted 3 lines · listuser

Hello all,

I am configuring a vpn between freeswan and windows 2000. I am

following the steps at
http://www.jacco2.dds.nl/networking/win2000xp-freeswan.html, to get the VPN up and running. using this I have a ppp tunnel between windows and linux, which is inside a l2tp tunnel which is again encrypted by IPSec. (the url gives the configuration in detail and I have followed it exactly)

Quoted 2 lines

Now the windows gets the proper ip and every thing is working as it

should except udp brpadcast, which is the reason why I set up the vpn (for a stock exchange, where the quots data comes as b'cast). Since the windows is having an ip in the same network their is no reason why B'cast should not work.

Quoted 2 lines

I searched a lot for any pointer but I found only one MS Knowledge

Base Article No. 253169 which says that B'cast is not supported in Windows IPSec. Is this the case with Linux also. Is their any thing that can be done to send B'cast also. Any help here will be much appriciated. I am working though Xmas to get this working :(

Quoted 7 lines

raj

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

- --
Jason A. Pattie
[email protected]
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.6 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iD8DBQE+C5vguYsUrHkpYtARAllUAJ9gdPutfG8WB37T1GNOfbsLUeFxpQCfVC3O 3ikJ51V0GTgMIM8yPQ6FQ/I=p9DK
-----END PGP SIGNATURE-----

Signature · 7 lines
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/