Skip to contentSkip to conversation

ingress/egress shaping

LARTC Björn Snippe 1 participant 3 messages Jan 27, 2003

lore
Share & tools
lore
#0 lore raw

Hi,

one short question: my setup consists of
[WWW]--[ISP's routerbox]--[Linux router/shaper]--[LAN]
Is it practical to create qdiscs/classes for both the inner and the outer NIC, in order to get complete control of both U/D traffic? Or would I better use IMQ? (control only one of the NICs?)

Thanks,
Björn

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 4 lines · David Boreham

With IMQ you'd have three NICs :)
IMQ is a virtual NIC.
So if you can achieve your goals with control on the two real NICs, do that.

Yes, that's clear to me (well, quite :)), but I read about the limitations of the ingress qdisc and that using a virtual imq device would give me the power to use classes even on incoming traffic. I just wanted to be sure not to be doing something stupid <:) So there's nothing wrong with my thinking?
What comes in from the WWW, I can shape on my inner NIC, and what leaves to the router/WWW, I can shape on the outer one?
What happens with all the traffic coming in on my inner NIC from my LAN that gets delayed/shaped in order to leave on my outer NIC? Will my inner NIC drop it, or will my Linux-router collect more and more packets, swell up to giant size and explode? :)

Thanks for any answer,
Björn

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#2 lore raw
In reply to Björn Snippe
Quoted 1 line · David Boreham

Repeat: queueing is done on outbound interfaces.

Got it. :)
[...]

Quoted 4 lines

I'd recommend that you setup a test machine with the tc stuff on it, and play around for a while. It's much easier to understand this stuff by performing experiments, using tcpdump , looking at the stats output from tc, and so on.

My 'test machine' is the up-and-running router for the dorm where I live in :)
It's running fine, and all the basic stuff works like I think it should, I just want to make sure I'm not wasting lots of performance by using a silly configuration...
Thanks a lot for reassuring me,

Björn

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/