ip rule nat
when doing somehitng like
ip rule add fwmark 3 nat 200.42.75.183 table ppp0 prio 1 (the idea is that packets that match the fwmark 3 change their source address to 200.42.75.183)..it first apply the nat and then routes to table ppp0 right?
in such case the, nat, why may be nat not being applyed? cause it doesnt work at all..it goes to that interface but does not nat the src address of the package.
any idea?
thanks
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Hello,
Quoted 9 lines · Esteban Ribicic
when doing somehitng like
ip rule add fwmark 3 nat 200.42.75.183 table ppp0 prio 1 (the idea is that packets that match the fwmark 3 change their source address to 200.42.75.183)..it first apply the nat and then routes to table ppp0 right?
in such case the, nat, why may be nat not being applyed? cause it doesnt work at all..it goes to that interface but does not nat the src address of the package.
any idea?
It is not supported but there is a patch:
Regards
--
Julian Anastasov <[email protected]>
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/