IMQ Setup-- first example
Hi all
thanks to Mr Devik , Mr Stef, Mr Patrick
At last iam able to successfully compiles with RH 9.0 with Iptables 1.2.8 with IMQ
not all are working fine with out any Errors, and iam able to see the traffic on IMQ Interface, when i mark the packets
on test base i have made a small example below, need confirmation
below example, iam trying to control up+down= 128kbps for the ip of x.x.x19
when try to download from internet, i was getting approximately 18.3Kil0 bytes
when i try up load the same time, to one of my local FTP server, which is located out side my LAN
iam able to transfer the rate of 14Kilo Bytes, and the download speed decreased to 4+ kilo bytes
so i assume my setup is running perfectly both the ways, but i did not use postrouting..... i have used only prerouting...
my setup is like this
----- FTP Server
LAPTOP--Switch--Eth1(Bridge)Eth0---Switch ---|
-----Internet
modprobe imq numdevs=1
tc qdisc add dev imq0 handle 1: root htb default 1 tc class add dev imq0 parent 1: classid 1:1 htb rate 1mbit
tc qdisc add dev imq0 parent 1:1 handle 10: htb default 5 tc class add dev imq0 parent 10: classid 10:1 htb rate 128kbit burst 3k
prio 1
tc class add dev imq0 parent 10: classid 10:2 htb rate 128kbit burst 3k
prio 2
tc class add dev imq0 parent 10: classid 10:5 htb rate 1mbit prio 3
tc qdisc add dev imq0 parent 10:1 handle 21:0 sfq tc qdisc add dev imq0 parent 10:2 handle 22:0 sfq tc qdisc add dev imq0 parent 10:5 handle 23:0 sfq
tc filter add dev imq0 protocol ip pref 1 parent 10: handle 1 fw classid
10:1
tc filter add dev imq0 protocol ip pref 2 parent 10: handle 2 fw classid
10:2
iptables -t mangle -A PREROUTING -i eth1 -j IMQ --todev 0 iptables -t mangle -A PREROUTING -i eth1 -s x.x.x.19 -j MARK --set-mark 1
ip link set imq0 up
so is this setup correct, i need to make some more correction, please suggest
thanks
hare
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Could some one respond to this post please
hare
Quoted 4 lines
Hi all
thanks to Mr Devik , Mr Stef, Mr Patrick
Quoted 8 lines
At last iam able to successfully compiles with RH 9.0 with Iptables 1.2.8 with IMQ
not all are working fine with out any Errors, and iam able to see the traffic on IMQ Interface, when i mark the packetson test base i have made a small example below, need confirmation
below example, iam trying to control up+down= 128kbps for the ip of
x.x.x19
Quoted 51 lines
when try to download from internet, i was getting approximately 18.3Kil0 bytes
when i try up load the same time, to one of my local FTP server, which is located out side my LAN
iam able to transfer the rate of 14Kilo Bytes, and the download speed decreased to 4+ kilo bytesso i assume my setup is running perfectly both the ways, but i did not use postrouting..... i have used only prerouting...
my setup is like this
----- FTP ServerLAPTOP--Switch--Eth1(Bridge)Eth0---Switch ---|
-----Internetmodprobe imq numdevs=1
tc qdisc add dev imq0 handle 1: root htb default 1 tc class add dev imq0 parent 1: classid 1:1 htb rate 1mbit
tc qdisc add dev imq0 parent 1:1 handle 10: htb default 5 tc class add dev imq0 parent 10: classid 10:1 htb rate 128kbit burst 3k
prio 1
tc class add dev imq0 parent 10: classid 10:2 htb rate 128kbit burst 3k
prio 2
tc class add dev imq0 parent 10: classid 10:5 htb rate 1mbit prio 3tc qdisc add dev imq0 parent 10:1 handle 21:0 sfq tc qdisc add dev imq0 parent 10:2 handle 22:0 sfq tc qdisc add dev imq0 parent 10:5 handle 23:0 sfq
tc filter add dev imq0 protocol ip pref 1 parent 10: handle 1 fw classid
10:1
tc filter add dev imq0 protocol ip pref 2 parent 10: handle 2 fw classid
10:2iptables -t mangle -A PREROUTING -i eth1 -j IMQ --todev 0 iptables -t mangle -A PREROUTING -i eth1 -s x.x.x.19 -j MARK --set-mark 1
ip link set imq0 up
so is this setup correct, i need to make some more correction, please suggest
Quoted 8 lines
thanks
hare_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/